Scribd
Upload
51 views1 page

Ac Fault

The document describes steps to diagnose and resolve an AC fault in a generator. It involves checking for a phase fault, low AC rail voltage, or high temperature. If a fault is detected, the generator is allowed to cool and tests are run to check the AC input voltage and measure voltages at various test points on different circuit boards to isolate the faulty component.

Uploaded by

ub170
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
51 views1 page

Ac Fault

The document describes steps to diagnose and resolve an AC fault in a generator. It involves checking for a phase fault, low AC rail voltage, or high temperature. If a fault is detected, the generator is allowed to cool and tests are run to check the AC input voltage and measure voltages at various test points on different circuit boards to isolate the faulty component.

Uploaded by

ub170
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

AC FAULT

- PHASE_FAULT is low for 15ms


- If AC-RAIL < 50VAC for 2s AC FAULT
- AC over temp.

DOES FAULT No
OCCUR
RESET GENERATOR
DURING
EXPOSURE?

Yes

LET THE No
No IS FAULT GENERATOR IS FAULT
PRESENT? COOL FOR 30 PRESENT?
MINUTES

Yes
Yes
MEASURE VAC
INPUT AT TB1
ON THE AC
1 CHASSIS

No IS THE VAC
CHECK THE VAC
200 VOLTS
AT THE SOURCE
+/- 10%?

Yes

ENABLE THE AC
CHASSIS. MEASURE
THE DC RAILS VIA
TP16 AND TP17 ON
THE SCB PWB

MEASURE THE No DOES THE


DC RAILS AT TB2 TEST POINTS
ON THE INV MEASURE >
CHASSIS 1.80 VOLTS?

Yes
1
No
DO THE RAILS MEASURE THE
REPLACE THE AC
MEASURE > VOLTAGE AT
CHASSIS. 254 VDC? TP13 ON THE
AC/FIL/FDBL BD.
Yes

MEASURE THE DC
RAILS AT JB1 4 Yes
DOES THE
AND 6 ON THE TEST POINT REPLACE THE AC
AC/FIL/FDBK BD. MEASURE > .1 CHASSIS.
VOLTS?

No
No
DO THE RAILS
REPLACE THE REPLACE THE
MEASURE >
INV CHASSIS. 254 VDC? SCB PWB

Yes

REPLACE THE
MULTIPLIER
CHASSIS.

END

You might also like