Scribd
Upload
56 views1 page

Manual Handbrake

This document provides instructions for adjusting a VNM handbrake. It includes the following key points: 1. The handbrake can be adjusted by turning the spring and elastomer clockwise to increase force or counterclockwise to decrease force. 2. The angle of inclination can be adjusted by removing screws, dragging out the adjustment part, rotating it to one of six positions, and securing it back in place. 3. Additional connections on the handbrake include a plug-in loadcell input, update firmware port, and USB connection to a PC.

Uploaded by

Andy L
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
56 views1 page

Manual Handbrake

This document provides instructions for adjusting a VNM handbrake. It includes the following key points: 1. The handbrake can be adjusted by turning the spring and elastomer clockwise to increase force or counterclockwise to decrease force. 2. The angle of inclination can be adjusted by removing screws, dragging out the adjustment part, rotating it to one of six positions, and securing it back in place. 3. Additional connections on the handbrake include a plug-in loadcell input, update firmware port, and USB connection to a PC.

Uploaded by

Andy L
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Content Connection Adjust Handbrake

VNM
HANDBRAKE
Quick Guide  At the left of  At the right of
Handbrake is: Handbrake is:
Plug-in loadcell 1. Plug in update firmware Adjust Spring & elastomer:
1 4 input by jack jack XH2.54-4P (ST-link)  Clockwise to made force + -
XH2.54-4P 2. Button DFU/Game Mode heavier.
2  Counter-clockwise to
made force lighter.
5

1 2
3 6 Adjust the angle of
inclination:
 Remove 2 screws left, right
 Drag out adjustment part
 Rorate it, it has 6 postions.
 At the bottom of Choose postion you want.
Handbrake is: Plug-in  Push that adjustment part
1. Typical VNM Handbrake 4. USB – GX12 cable
Connect to PC by in sliding slot.
2. Addon (horizontal arm; red, 5. Steel springs
USB – GX12 cable  Screw up and play.
blue spring & green elastomer) 6. Back plate for
3. Hexagon alley key Handbrake and Shifter

Table Clamp Exchange Elastomer & Spring

Remove scews

You might also like