Scribd
Upload
46 views

Assignment 1 2020

This document provides instructions for Assignment 1 of the MMB 231 Engineering and Computer Aided Drafting course at the University of Botswana's Faculty of Engineering & Technology. Students are to individually submit by September 22, 2020 technical drawings of a bevel gear support and shaft bracket from diagrams provided. For each diagram, students must create specific orthographic views in either first or third angle projection, including a sectional view, side view, top view, and title block. All drawings must be fully dimensioned for accurate marking.

Uploaded by

Nɩʜɩɭɩstic Ucʜɩʜʌ Sʌsʋĸɘ
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
46 views

Assignment 1 2020

This document provides instructions for Assignment 1 of the MMB 231 Engineering and Computer Aided Drafting course at the University of Botswana's Faculty of Engineering & Technology. Students are to individually submit by September 22, 2020 technical drawings of a bevel gear support and shaft bracket from diagrams provided. For each diagram, students must create specific orthographic views in either first or third angle projection, including a sectional view, side view, top view, and title block. All drawings must be fully dimensioned for accurate marking.

Uploaded by

Nɩʜɩɭɩstic Ucʜɩʜʌ Sʌsʋĸɘ
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

UNIVERSITY OF BOTSWANA

FACULTY OF ENGINEERING & TECHNOLOGY (FET)


MMB 231: ENGINEERING AND COMPUTER AIDED DRAFTING

Assignment 1 2020

Instructions: Work individually and submit by Tuesday 22 September 2020

Figures 1 and 2 below represent a bevel gear support and a shaft bracket respectively. Study
the diagrams carefully and answer the questions that follow. Use appropriate scale where
deemed necessary, and approximate dimensions where not indicated.

1. For figure 1;

Draw the following views in third angle projection:


a) A sectional front view on a plane through A-A. 13 Marks
b) A side view from B. 13 Marks
c) A top view. 13 Marks
d) Provide a title block. 5 Marks
e) Dimension your drawing fully. 6 Marks

2. For figure 2;

Draw the following views in first angle projection:


a) A front view from A. 13 Marks
b) A sectional side view from B on the centre line. 13 Marks
c) A top view. 13 Marks
d) Provide a title block. 5 Marks
e) Dimension your drawing fully. 6 Marks

Page 1of 1
Figure 1: Bevel gear support.

Page 2of 1
Figure 2: Shaft bracket.

Page 3of 1

You might also like