Scribd
Upload
20 views1 page

CHK ADJ: Periodic Check and Adjustment

This document provides instructions for periodically checking and adjusting a control lever and throttle link rod, as well as checking gear shift operation. Key steps include setting the control lever to full retard and checking contact with the crankcase, aligning a flywheel magnet mark with a pulser coil pointer, and adjusting the control lever screw length if not aligned. It also instructs to check smooth gear shifting, align marks on a bracket and shift lever, and adjust the shift cable if necessary.

Uploaded by

PHUONG NGUYEN
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
20 views1 page

CHK ADJ: Periodic Check and Adjustment

This document provides instructions for periodically checking and adjusting a control lever and throttle link rod, as well as checking gear shift operation. Key steps include setting the control lever to full retard and checking contact with the crankcase, aligning a flywheel magnet mark with a pulser coil pointer, and adjusting the control lever screw length if not aligned. It also instructs to check smooth gear shifting, align marks on a bracket and shift lever, and adjust the shift cable if necessary.

Uploaded by

PHUONG NGUYEN
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

CHK

ADJ Periodic check and adjustment

8. Set the control lever 2 2 to the full retard 11. Install the throttle link rod and connect
position, and then check that the adjust- the throttle cable.
ing screw 6 comes in contact with the
crankcase.
2 Checking the gear shift operation
6 1. Check that the gear shift operates
smoothly when shifting from “N” to “F” or
“R”. Adjust the shift cable if necessary by
turning the cable joint.

N
F R
R

F
68830280

68830340
9. Check that the mark b on the flywheel
magnet is aligned with the pointer 4 on
the pulser coil assembly. 2. Set the gear shift to “N” position.

b 3. Loosen the locknut 1, remove the pin 2


4
and then disconnect the shift cable joint
3.

2
3 1

68830290

10. If it is not aligned, check the screw out


length f of the adjusting screw 6.
68830350

4. Make sure to align the mark a on the


bracket 4 with mark b on the shift lever
5.
f
5
68830300

Specified length f (full retard,


reference data): b
12.5–13.5 mm (0.49–0.53 in)

a 4 68830356

3-13 6885J11

You might also like