Scribd
Upload
30 views2 pages

DDP Sscje

The document contains a 10 question practice set on electrical engineering concepts for exams like SSC JE & RRB JE. The questions cover topics like series RL circuits, induced voltage in coils, effects of reversing current in an electromagnet, interpreting ohmmeter readings, calculating efficiency in a power supply, properties of parallel resonant filters, adding inductances in series, effects of changing the RC time constant in an integrator, and calculating impedance in a circuit containing resistors and inductors. An advertisement is also included providing contact information for a coaching institute called FORMULATOR campus in Patna, India.

Uploaded by

binit ranjan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
30 views2 pages

DDP Sscje

The document contains a 10 question practice set on electrical engineering concepts for exams like SSC JE & RRB JE. The questions cover topics like series RL circuits, induced voltage in coils, effects of reversing current in an electromagnet, interpreting ohmmeter readings, calculating efficiency in a power supply, properties of parallel resonant filters, adding inductances in series, effects of changing the RC time constant in an integrator, and calculating impedance in a circuit containing resistors and inductors. An advertisement is also included providing contact information for a coaching institute called FORMULATOR campus in Patna, India.

Uploaded by

binit ranjan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

……………..

Team FORMULATOR

Daily Practice Set (Electrical Engg) for SSC JE & RRB JE


SET-01
1. In a series RL circuit, 12 V rms is measured across the resistor, and 14 V rms is measured
across the indicator. The peak value of the source voltage is
A. 18.4 V
B. 26.0 V
C. 2V
D. 20 V

2. The induced voltage across a coil with 250 turns that is located in a magnetic field that is
changing at a rate of 8 Wb/s is
A. 1,000 V
B. 2,000 V
C. 31.25 V
D. 3,125 V .

3. When the current through the coil of an electromagnet reverses, the


A. direction of the magnetic field reverses
B. direction of the magnetic field remains unchanged
C. magnetic field expands
D. magnetic field collapses .

4. When the pointer of an analog ohmmeter reads close to zero, the resistor being measured
is
A. overheated
B. shorted
C. open
D. reversed

5. A power supply produces a 0.6 W output with an input of 0.7 W. Its percentage of efficiency
is
A. 8.57%
B. 42.85%
C. 4.28%
D. 85.7%

Add: FORMULATOR campus, 1st floor, opp NMCH, near railway line crossing, Bazar samiti road, Patna
Mob: 8539965784/ 7277084298
6. In a certain parallel resonant band-pass filter, the resonant frequency is 14 kHz. If the
bandwidth is 4 kHz, the lower frequency
A. is 7 kHz
B. is 10 kHz
C. is 12 kHz
D. cannot be determined .

7. A 2 mH, a 3.3 mH, and a 0.2 mH inductor are connected in series. The total inductance is
A. 55 mH
B. less than 0.2 mH
C. less than 5.5 mH
D. 5.5 mH

8. If the RC time constant of an integrator is increased, as the time constant is increased


A. the capacitor charges more during a pulse and discharges less between pulses
B. the capacitor charges less during a pulse and discharges more between pulses
C. the capacitor charges more during a pulse and discharges more between pulses
D. the capacitor charges less during a pulse and discharges less between pulses

9. Determine VTH when R1 is 180 Ω and XL is 90 Ω.


A. 13563.4° V
B. 13.563.4° V
C. 12.20° V
D. 1220° V.

10. For the circuit shown, determine ZTH for the portion of the circuit external to RL.
A. 66.7 –33.7° k
B. 6.67–333.7° k
C. 14.4 –56.3° k
D. 1.44 –33.7° k

Add: FORMULATOR campus, 1st floor, opp NMCH, near railway line crossing, Bazar samiti road, Patna
Mob: 8539965784/ 7277084298

You might also like