Microwave Communication MCQ

Download as pdf or txt
Download as pdf or txt
You are on page 1of 4

By OnlineInterviewQuestions.

com
Microwave Communication MCQ Test

Take Microwave Communication MCQ Test & Online Quiz to test


your Knowledge
Below is the Microwave Communication MCQ test that checks your basic knowledge of Microwave
Communication. This Microwave Communication MCQ Test contains 20 Multiple Choice Questions. You
have to select the right answer to the question. Finally, you can also take the Online Quiz from the Take
Microwave Communication Quiz Button.

Q1. In which of the following places microwave resonators are used?

A. Microwave oscillators
B. Microwave frequency metres
C. Microwave narrow band amplifier
D. All of the above

Q2. A wave guide section in a microwave circuit acts as HP filter.

A. True
B. False

Q3. Which of the following is the progressive decrease of signal strength with increasing
distance?

A. Modulation
B. Radiation
C. Attenuation
D. None of the above

Q4. The usual mixer stage is ........ In a radar-set receiver.

A. A tunnel diode
B. A silicon crystal
C. A Rochelle salts crystal
D. None of the above

Q5. The STC circuit is used to reduce interference from the effects of sea return In a
pulsed radar set.

A. True
B. False

Q6. .......... is not a common microwave application.

A. Telephone
B. Radar
C. Mobile radio
D. Satellite communications

Q7. Stripline and microstrip transmission lines are usually made with .............

A. PCBs
B. Coax
C. Twisted pair
D. Parallel wires

Q8. Which of the following is a popular microwave mixer diode?

A. Gunn
B. Impatt
C. Varactor
D. Hot carrier

Q9. The velocity factor of a transmission line depends on

A. Skin effect
B. Temperature
C. Relative permittivity of dielectric
D. None of the above
Q10. In a circular waveguide the dominant mode is TE11.

A. True
B. False

Q11. In a directional coupler

A. isolation (dB) equals (coupling) (directivity)


B. isolation (dB) equals coupling plus directivity
C. coupling (dB) equals isolation plus directivity
D. None of the above

Q12. Which of the following lines is non-radiating?

A. Coaxial
B. Open two wire
C. Both A & B
D. None of the above

Q13. Which of the following parameters is negligible in transmission lines?

A. L
B. G
C. R
D. C

Q14. At microwave frequencies, the size of antenna becomes

A. Large
B. Small
C. Very large
D. Very small

Q15. The fabrication of microstrip line is done by

A. Oxidation
B. Cladding
C. Photo etching
D. Printed circuit technique

Q16. Which of the following noise becomes important at microwave frequencies?

A. Short noise
B. Thermal noise
C. Flicker noise
D. Transit time noise

Q17. Which of the following devices uses a slow wave structure?

A. TWT
B. Reflex klystron oscillator
C. Klystron two cavity amplifier
D. Klystron multicavity amplifier

Q18. A waveguide section in a microwave circuit acts as

A. LP filter
B. HP filter
C. Bandpass filter
D. Band stop filter

Q19. Microwave frequency range extends from

A. 3 MHz to 30 MHz
B. 30 MHz to 300 MHz
C. 500 MHz to 30,000 MHz
D. None of the above

Q20. Impedance inversion may be obtained with

A. A half wave line


B. A quarter wave line
C. A short circuited stub
D. An open circuited stub

Please Visit OnlineInterviewquestions.com to download more pdfs

You might also like