Prueba de Presion de Clutch Transmision 310 SJ JD

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

Página 1 de 2

TM10131 - 310SJ Backhoe Loader (S.N. —159759)


Clutch Pressure Test

Clutch Pressure Test

-: Specifications

SPECIFICATIONS
Transmission Oil Temperature 75-85°C
167—185°F
Engine Speed 1475—1525 rpm
Direction and Speed Clutches 1650—2050 kPa
16.5—20.5 bar
239—297 psi
Neutral Disconnect Deactivated Pressure 0 kPa
0 bar
0 psi

-: Service Equipment and Tools

SERVICE EQUIPMENT AND TOOLS


Quick Coupler (M10 x 1)
JT02156A Digital Pressure/Temperature Analyzer

1. Remove floor panel in cab or ROPS.

2.
TX1047519-UN: Clutch Pressure Test Ports

LEGEND:

19 - Low Range Forward Pressure Test Port


20 - High Range Forward Pressure Test Port
21 - 1st Speed Clutch Orifice / Pressure Test Port (Alternate) (K1)
22 - 2nd Speed Clutch Pressure Test Port
32 - Reverse Clutch Pressure Test Port
33 - Low Range Forward Pressure Test Port (Alternate)
34 - 3rd Speed Clutch Pressure Test Port
37 - 1st Speed Clutch Pressure Test Port

Connect JT02156A digital pressure/temperature analyzer in appropriate port (19, 20 22, 32—34 and 37). See JT02156A Digital
Pressure and Temperature Analyzer Kit Installation . (Group 9025-25.)

3. Warm transmission oil to specification. See Transmission Oil Warm-Up Procedure . (Group 9020-25.)

Item Measurement Specification

Transmission Oil Temperature 75-85°C

file://C:\ProgramData\Service ADVISOR\Temp\TM10131_09001faa805a58f0.html 22/09/2021


Página 2 de 2

167—185°F

4. NOTE:

All clutch pressures should be the same.

Raise machine off of ground. Engine speed at specifications and park brake OFF and transmission control lever in forward or
reverse, record pressure in all speed ranges.

Item Measurement Specification

Engine Speed 1475—1525 rpm

Direction and Speed Clutches Pressure 1650—2050 kPa


16.5—20.5 bar
239—270 psi

5. Low pressure in one direction indicates a leakage in that pack or solenoid. Low pressure in both directions indicates low system
pressure or leakage in the speed clutch. See Transmission System Pressure Test . (Group 9020-25.)

6. With transmission control lever in neutral, a slight pressure recorded in either the forward or reverse test port could indicate that the
ball in the clutch shaft came out (lube passage).

7. With transmission control lever in neutral, pressure recorded in the speed clutch test ports could indicate a problem with the time
delay relay. See System Functional Schematic and Section Legend . (Group 9015-15.)

NOTE:

When neutral disconnect is deactivated, pressure should be zero.

Item Measurement Specification

Neutral Disconnect Deactivated Pressure 0 kPa


0 bar
0 psi

JH38101,00001DB-19-20100823

file://C:\ProgramData\Service ADVISOR\Temp\TM10131_09001faa805a58f0.html 22/09/2021

You might also like