Ⅵ.

OPERATION VIDEO INDOOR PHONE

1.Press Power switch to open/close power supply to indoor/outdoor unit. A4-F5C (COLOR) A4-F5C-7 (COLOR)
2.When visitor presses the Call button of outdoor unit, the corresponding indoor unit will ring and
display visitor's image, you may Introduction
a. choose not to answer the call, the image will automatically disappear 90 seconds later;
The model number is located on the bottom and record the serial
b. or press( )to talk with the visitor. To end the talk, press( ) again.
number in the space provided below .Refer to these numbers whenever
3. Press( )on the indoor phone,can monitor Entrance 1; by pressing again, it returns to standby state;
you call upon your dealer regarding this product.
press ( ) on the indoor phone,can monitor Entrance 2; by pressing again, it returns to standby state;
4 . The user may press( ) to unlock the electronically controlled door when talking or monitoring. CAUTION: TO REDUCE THE RISK
WARNING : TO REDUCE THE RI--
5. Regulate chromaticity of the screen with Chroma control. SK OF FIRE OR SHOCK HAZARD OF FIRE OR SHOCK HAZARD AND
6. Regulate brightness of the screen with Brightness control. ANNOYING INTERFERENCE,USE
DO NOT EXPOSE THIS EQUIPM -
THE RECOMMEDED ACCESSO-
7.Regulate volume of speaking with Volume control. ENT TO RAIN OR MOISTURE
CAUTION RIES ONLY
8.Regulate volume of ringing with Ringtone control. RISK OF ELECTRIC SHOCK
DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF CAUTION: TO REDUCE THE RISK CAUTION: TO REDUCE THE RISK
Ⅶ. TROUBLE SHOOTING GUIDE
ELECTRIC SHOCK,DO NOT REMOVE OF FIRE OR SHOCK HAZARD， OF FIRE OR SHOCK HAZARD,RE
COVER (OR BACK). NO USERSERV- REFER CHANGE OF SWITCH SE- -FERMOUNTING OF THE OPTI-
ICEABLE PARTS INSIDE. REFER SE-
No. Problem Possible Cause RVICING TO QUALIFIED SERVICE PE-
TTING INSIDE THE UNIT TO QU- ONAL INTERFACE BOARD TO
ALFIED SERVICE PERSONNEL QUALIFIED SERVICE PERSONNEL
The power is not properly connected , or no electrification is available. RSONNEL.

1 Unit totally dead. The power switch is turned off.

The polarization of wiring between Indoor and outdoor units is uncorrected.
This symbol is intended to alert the user to the This symbol is intended to alert the user to the presence
Call and communication The brightness is not properly adjusted,or the video line(white) is subject to dangerousvoltage
presence of uninsulated “dangerousvoltage” of important operating and maintenance (servicing)
2 Workable,but no display. open circuit or short circuit. within the product's enclosure that may be of intructions in the literature accompanying the
sufficient magnitude to constitute a risk of appliance .
Call allowed, but with no The voice line (red)is subject to open circuit or short circuit.
3 Electric shock to persons.
Communication.

Ⅰ. F5 SYSTEM OUTLINE COMPONENTS. Ⅱ.PARTS CHECKLIST

SPECIFICATIONS Indoor Phone ( Monitor ) 1
I. Indoor Unit Mounting Bracket 1
4
OR OR Screw (ST4×25mm) 2
Model No. A4-F5C A4-F5C-7 Connection Cable
A4-F5C A4-M1C A4-M2C A4-M4C 4# line 2
Display 5”COLOR TFT- LCD 7”COLOR TFT- LCD A4-F5C-7 2# line 1
Door
Release User Manual 1
Pattern of Wiring 4-line (polarized)
A-121/ A C ( 1 0 0～2 4 0 V )
Power AC100- 240V A-122
A C ( 1 0 0～2 4 0 V ) Power
Ding-ding dong, adjustable volume ( Optional Accessories )
Ringtone

Talking Hand-free

Cable condition 50 m/165 ft .(RVV 22 # 4×0.65mm)

User Manual
Ambient Temperature 0~40ºC

Net Weight 0 . 751 Kg 4# Line

Dimension( W×D×H) 220mm×160mm×49.5mm Screw

(ST4×25mm)

I ndoor Phone( Monitor ) Mounting Bracket 2# Line

V090615
MFS0 302
4 1
Ⅲ.FEATURES
* OPTION 2 (SINGLE INDOOR PHONE/TWO CAMERAS/IMAGE MEMORIER)
1) Loudspeaker INDOOR PHONE
2) MIC IMAGE
OUTDOOR1 OUTDOOR2
3) Screen 1 2 3 4 1 2 3 4 1 2 #3 #4 5 6 7
11 10 9 12
4) Power Indicator LED
5) Monitor Button Camera1 Camera2
6) Talk Button
1
7) Ringtone Button 1 2 3 4 1 2 3 4
3
8) Release Button
1 2 3 4 5 6 7
9) Volume Control
Image Memory
2
10) Brightness Control Door Door ( Optional
4 6 Release Release
8 11) Chroma Control Accessories )
5
7 12) Power Supply A - 121 / A - 122 A - 121 / A - 122

Ⅳ.WIRING 13) Power ON/OFF Switch Power ( Optional Accessories ) Power ( Optional Accessories )
IMAGE 14) Ringtone Volume Control
1 2 3 4 5 6 7

Note: Using component “2# LINE” to connect #3,#4 shut pin when you are not
13 AWG 22
OFF OUTDOOR1 OUTDOOR2 using image memory. Wrie
1 2 3 4 1 2 3 4 ( 0 . 65mm )
ON
Wiring is not supplied with your Video Doorphone system.Use only AWG #22
wire (0.65mm, 4-wire) and follow the appropriate wiring diagrams exactly for
optimum system performance and safety.
14 When planning to install the initial system, consider future system extension.
The total wire length for a single camera and monitor system(or any
combination of additional camera or monitors) must not exceed 50m for
1 2 3 4 1 2 3 4 1 2 #3 #4 5 6 7 optimum performance.

Door Door
Release Release Ⅴ. INSTALLATION

1 2 3 4 1 2 3 4 1.Detemine the mounting locations for both the outside camera and inside monitor.
A-121/ A-121/
1 2 3 4 5 6 7 2. At the selected monitor mounting location , attached the mounting bracket Mounting
A-122 A-122
ImageMemory securely to t h e wall. drill a h ole in the center area of the bra cket just large Bracket
Power Power
( Optional ( Optional ( Optional enough for the electrical wirin g to pull through the hole. Connect the ele ctrical
Camera1 Accessories ) Camera2 Accessories ) Accessories )
w ires from the camera unit to the monitor.
3 . Attach the wired monitor unit to the wall mounting bracket by setting the
monitor over the four bracket hooks and sliding it down , Insert the tiny
* BASIC(SINGLE CAMERA/SINGLE INDOOR PHONE) * OPTION 1 (TWO CAMERAS/SINGLE INDOOR PHONE) Mounting
machi ne s crew into the hole in the tab at the top of the bracket to hold the Screw
INDOOR PHONE INDOOR PHONE monitor in place.
4.. Plug the AC power cord into a standard household outlet.
IMAGE IMAGE
1 2 #3 #4 5 6 7 1 2 #3 #4 5 6 7 5. Place the power“ON/OFF”switch in the “ON” position.

OUTDOOR1 OUTDOOR2 OUTDOOR1 OUTDOOR2 Important Mounting Notes:

1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4
Do not install the monitor and camera units where they will be exposed to dirt,
direct sunlight (or other strong light) , moisture ,high temperature( over 40℃ )
Camera2 Camera1 Camera2 or high humidity conditions.
Do not select an installation location subjected to vibration or pounding.
1 2 3 4 1 2 3 4 1 2 3 4
Select a mounting location close to an AC outlet where it is easy to view the
screen and operate the monitor.

Door Door Door

Release Release Release
A - 121 / A - 122 A - 121 / A - 122
A - 121 / A - 122
Power ( Optional Accessories ) Power ( Optional Accessories )
Power ( Optional Accessories )

2 3