0% found this document useful (0 votes)
116 views1 page

3D+Sprint+ +Minimum+Firmware+Guide

This document lists the latest firmware versions required for various 3D printer models to be used with 3D Sprint 3.1 software. It also shows the minimum firmware version required. Several printer models, their latest firmware, and minimum versions supported by the 3D Sprint 3.1 software are displayed in a table. A note at the bottom explains that the latest firmware is needed for direct use, but an earlier version can also be used in virtual printer mode to create build files.

Uploaded by

Alireza Kazemi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
116 views1 page

3D+Sprint+ +Minimum+Firmware+Guide

This document lists the latest firmware versions required for various 3D printer models to be used with 3D Sprint 3.1 software. It also shows the minimum firmware version required. Several printer models, their latest firmware, and minimum versions supported by the 3D Sprint 3.1 software are displayed in a table. A note at the bottom explains that the latest firmware is needed for direct use, but an earlier version can also be used in virtual printer mode to create build files.

Uploaded by

Alireza Kazemi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Version 3.

1
Minimum Firmware Version
Minimum firmware version
Printer Model Latest firmware version
for 3D Sprint 3.1

ProJet uSLA 1200 v1.0.60.0 v1.0.60.0

FabPro 1000 V128 V128

ProJet MJP 2500 v5.1.24 v5.1.24


ProJet MJP 2500 Plus

ProJet MJP 2500W v3.1.13 v3.1.13

ProJet MJP 2500IC v1.6.13 v1.6.13

ProJet MJP 35X0 v5.13.9889 v5.13.9889

ProJet MJP 3600(W) v6.6.10940 v6.6.10940

ProJet MJP 5500X-E v7.1.10943 v7.1.10943

ProJet MJP 5600 v7.1.10943 v7.1.10943

ProJet SLA 6000 v1.6.2959 v1.6.2959

ProJet SLA 7000 v1.6.2959 v1.6.2959

ProX SLA 800 v1.2.6640/442 v1.2.6640/442

ProX SLA 950 v1.2.6640/442 v1.2.6640/442

iPro 8000 v2.0 v2.0

iPro 9000SV v2.0 v2.0

ProX SLS 6100 v6.3.527 (on Windows 10) v6.3 (on Windows 10)

NextDent 5100
v1.1.2 v1.1.1-3
Figure 4 Standalone

Figure 4 Modular GA SW v1.0.3-8 + CM SW image v1.0.3-8 v1.0.3-8

Note: The latest firmware will be needed to use 3D Sprint direct with the Printer. However you can also use
3D Sprint in ‘Virtual Printer’ mode with an earlier firmware to create a build file that you can then transport
to the printer manually.

You might also like