Scribd
Upload
932 views98 pages

PoC - Aruba Central Example

This document outlines the setup of a WiFi guest service using Aruba Central and a local Aruba switch. Key steps include: 1. Configuring the Aruba branch gateway and switch via CLI for VLANs and interfaces. 2. Registering an Aruba AP to Aruba Central and upgrading its firmware. 3. Configuring a guest SSID and captive portal in Central for social login via Facebook. 4. Importing the existing switch configuration into Central to manage the switch remotely.

Uploaded by

Ali
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
932 views98 pages

PoC - Aruba Central Example

This document outlines the setup of a WiFi guest service using Aruba Central and a local Aruba switch. Key steps include: 1. Configuring the Aruba branch gateway and switch via CLI for VLANs and interfaces. 2. Registering an Aruba AP to Aruba Central and upgrading its firmware. 3. Configuring a guest SSID and captive portal in Central for social login via Facebook. 4. Importing the existing switch configuration into Central to manage the switch remotely.

Uploaded by

Ali
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 98

WiFi Guest

Service
PoC - Aruba Central
PoC - Diagram VLAN 10
172.16.0.200/24
AOS-SW v16.07

Port 4

AOS v8.2.2
Cable Modem

SSID
Internet Store_Free_WiFi

Guest
Aruba Central

VLAN 10: 172.16.0.0/24 - Employee/Management VLAN


VLAN 20: 192.168.10.0/24 - Guest VLAN <–> SSID “Store_Free_WiFi”
VLAN 90: 192.168.0.0/24 - Cable Modem VLAN
Agenda

• Setup Mobility Controller as Branch Gateway


• Setup Aruba switch 2930F via CLI
• Register AP 303H @Aruba Central

• Setup Aruba Central


• Setup Facebook Wi-Fi
• Setup Social Login Facebook
• Import existing switch configuration and manage the
switch via Aruba Central
Setup Branch Gateway
Factory reset to Branch Gateway
Power on the 7010 Branch Gateway
Complete the setup wizard
Check configuration made via wizard
• Config – Interfaces – Click on “+”
• Vlans created
• Interfaces – VLANs – VLAN90 – NAT Outside
• Interfaces – VLANs – VLAN10 – NAT Inside
• Interfaces – VLANs – VLAN20 – NAT Inside
• Config – Interfaces - Ports – Click on GE 0/0/5 – Mode Trunk
• System - General – Clock NTP
• Submit Changes
• Disable ADP via CLI
• Show running-config Branch Gateway
Setup switch via CLI
• Show running-config. 2930F switch
Register AP 303H
Aruba Central
• Add AP and Assign subscriptions in Aruba Central
• PC connected to interface 4 -- Check access to Internet
• Factory reset to AP via console port
• Check DHCP -- 172.16.0.2 IP address assigned to AP

• AP 303 set as Master (IAP)


• After 5min à Firmwave Upgrade from Aruba Central
• AP managed from Aruba Central (athena-mgmt)
• AP is ready to be configured via Aruba Central
Setup Aruba Central
• Site Label created and assigned to AP
• Assign Label to AP
• Create a new group
• Move the AP to the new Group
• Change the name to AP
• Change the name to AP
• Firmware upgrade to recommended version
• Check firmware version running
• Set installation type
• Enable DPI
• Configure DHCP for Guest SSID
• Create splash page
• Configure Redirect URL
• Configure Logos, Background and Terms&Conditions
• Localization
• Test Captive Portal
• Create Guest SSID
• Guest SSID – Limit Bandwidth
• Guest SSID – Set VLAN and DHCP Server
• Guest SSID – Set Captive Portal
• Guest SSID – Deny access to Employee Network
• Testing service using Android - smartphone
• Guest SSID – Device connected
Setup Facebook Wi-Fi
• Create Facebook Page
• Page created

https://www.facebook.com/Demo-WifiLogin-303563190479308
• Enter a location
• Edit Captive Portal
• Enable Facebook WiFi
• Edit Facebook WiFi configuration
• Enter facebook credentials
• Select Facebook page
• Facebook Wi-Fi login enabled
Setup Social Login
Facebook
• Copy the URL mapped in the Splash page
• Click on “ Create new App”
• Name the app
• Click on Facebook Login - Setup
• Click on web
• Enter URL -- Aruba Central
• Click on Settings
• Check OAuth client is set to “yes” and paste the URL -- append “/oauth/reply”
• Click on “app review”
• Public the Facebook App
• Copy App ID and App Secret
• Create a new splash page
• Enter App ID and App Secret
• New splash page ready
• Edit the Wireless SSID
• Security – Splash page Profile
• Testing
• Done!
Import switch configuration
to Aruba Central
• Check serial and MAC Address
• Check default gateway and DNS server config
• Add switch to Aruba Central
• Assign subscription to Switch
• Enter the command “include-credentials”
• Set the management VLAN, DNS server and cloud provisioning
• Switch registered to Aruba Central
• Switch in Central as “unprovisioned”
• Create new Template Group
• Move the switch to the new Template Group
• Click on “config” template
• Click on “+”
• Create the new template importing the existing configuration
• Click on save to create the new template
• Done! Switch is managed by Central

You might also like