Fitjee Paper Class 10 Electrcity
Fitjee Paper Class 10 Electrcity
Section – I (PHYSICS)
PART – A
Single Correct Choice Type
2. The mass of three wires of copper are in the ratio of 1 : 3 : 5 and their lengths are in the ratio 5 : 3 :
1. The ratio of their electrical resistance is
(A) 1 : 3 : 5 (B) 5 : 3 : 1 (C) 1 : 15 : 125 (D) 125 : 15 : 1
3. If the ammeter is the given circuit reads 2A, the heat produce by R resistor in 10 sec.
3
R
6
A
12V
(A) 20 J (B) 40 J (C) 160 J (D) 80 J
3
R2 = 4
100V
FIITJEE Ltd, B – 4, Sec – 16, Noida (U.P), 201301, Ph : 0120 - 3105005, 4754800, Fax : 0120 - 4271214
CPT-1-Ascent-X(B Lot)PCM-IITJEE Stage-I-3
6. The potential difference across the terminals of an ideal battery when an current is withdrawn from it
is
(A) equal to its e. m. f. (B) greater than its e. m. f.
(C) smaller than its e. m. f. (D) zero
6
C
18
20
9. Two light bulbs shown in the circuit have ratings A(24 V, 24 W) and B (24 V and 36 W) as shown in
Fig. When the switch is closed
(24 V, 24 W)
12 V A
B
12 V
(24 V, 36 W)
(A) the intensity of light bulb A increases (B) the intensity of light bulb A decreases
(C) the intensity of light bulb B increases (D) the intensity of light bulb B decreases
10. Two wires made of same material have the same length but difference radius. They are connected
in parallel to a battery. The quantity that is not the same for the wire is
(A) Potential difference (B) Current
(C) Resistance (D) Conductivity
FIITJEE Ltd, B – 4, Sec – 16, Noida (U.P), 201301, Ph : 0120 - 3105005, 4754800, Fax : 0120 - 4271214
CPT-1-Ascent-X(B Lot)PCM-IITJEE Stage-I-4
11. Which of the following expression has same unit as energy (where symbols have their usual
meaning)
I2 V2
(A) qV (B) (C) t (D) VIt
R R
12. Which of the following are correct for given circuit diagram? I1
6
3
24
(A) I1 A (B) I 2 Zero
9 3
4
(C) I 3 A (D) I3 2 A I2 I3
3 6
12
24 V
PART - B
MATRIX TYPE
12
45 V, r = 1
Now match the column
Column – I Column – II
(A) Current flowing through 3 resistance (in (P) 24
A)
(B) Potential across 12 resistance (in volt) (Q) 4
(C) Potential across 4 resistance (in volt) (R) 36
(D) Power developed in 4 resistance (in Watt) (S) 144
FIITJEE Ltd, B – 4, Sec – 16, Noida (U.P), 201301, Ph : 0120 - 3105005, 4754800, Fax : 0120 - 4271214
CPT-1-Ascent-X(B Lot)PCM-IITJEE Stage-I-5
3V 12 12 12 12
A4 A2
Column – I Column – II
(A) Reading of ammeter A1 is (P) 1
A
4
(B) Reading of ammeter A2 is (Q) 1
A
2
(C) Reading of ammeter A3 is (R) 3
A
4
(D) Reading of ammeter A4 is (S) 1A
PART – C
Numerical Based
1
1. An electric iron consumes energy at a rate of 800 W. If mains voltage is 200V then what will be th
10
of resistance of the iron?
2. Three resistors each of resistance 3 are first connected in series and then in parallel. What is the
ratio of total resistance of the circuit in series combination to the total resistance in parallel
combination?
3. If the current in electric bulb increases by 200%, then power in bulb increases by x100 percent.
What will be value of x(Assume resistance remains constant)
19
4. A body has charge 8 10 Coulomb. n protons are transferred in the body. Now body contains
19
17.6 10 C. Find out value of n.
5. If 160 J of work is required to carry a 40 C charge slowly from point A to B, then potential difference
between these point is (in volt)
6. An electric heater of 2 KW is used for 3 hour at 200 V. Determine energy consumed by it in (Killo-
Watt-Hour)
FIITJEE Ltd, B – 4, Sec – 16, Noida (U.P), 201301, Ph : 0120 - 3105005, 4754800, Fax : 0120 - 4271214