Scribd Logo
Upload

Welcome to Scribd!

  • 92 views

    303-13 Evaporative Emissions - Removal and Installation - Evaporative Emission Canister

    Uploaded by

    CARLOS LIMADA

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    303-13 Evaporative Emissions - Removal and Installation - Evaporative Emission Canister

    Uploaded by

    CARLOS LIMADA
    92 views3 pages

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    92 views3 pages

    303-13 Evaporative Emissions - Removal and Installation - Evaporative Emission Canister

    Uploaded by

    CARLOS LIMADA

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 3

    Page 1 of 3

    303-13 Evaporative Emissions - 2.3L EcoBoost (201kW/273PS) 2019 Ranger


    Removal and Installation Procedure revision date: 10/15/2018

    Evaporative Emission Canister

    Base Part Number: 9E857

    Removal

    WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on
    or near any fuel-related component. Highly flammable mixtures may be present and may be ignited.
    Failure to follow these instructions may result in serious personal injury.

    WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment
    of any type when working on or near any fuel-related component. Highly flammable mixtures may be
    present and may be ignited. Failure to follow these instructions may result in serious personal injury.

    WARNING: Always disconnect the battery ground cable at the battery when working on an
    evaporative emission (EVAP) system or fuel-related component. Highly flammable mixtures may be
    present and may be ignited. Failure to follow these instructions may result in serious personal injury.

    NOTE: Removal steps in this procedure may contain installation details.

    1. With the vehicle in NEUTRAL, position it on a hoist.


    Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).

    2.
    l Disconnect the EVAP canister electrical connector.
    l Disconnect the vent hose.
    l Disconnect the EVAP canister quick connect couplings.
    Refer to: Quick Release Coupling (310-00 Fuel System - General Information - 2.3L EcoBoost
    (201kW/273PS), General Procedures).

    http://www.fordservicecontent.com/Ford_Content/vdirsnet/workshop/ody/~WSKG/US/EN/... 1/9/2019
    Page 2 of 3

    3.
    1. Remove the fastener.
    Torque: 133 lb.in (15 Nm)
    2. Remove the EVAP canister.

    Installation

    http://www.fordservicecontent.com/Ford_Content/vdirsnet/workshop/ody/~WSKG/US/EN/... 1/9/2019
    Page 3 of 3

    1. To install, reverse the removal procedure.

    Copyright © 2019 Ford Motor Company

    http://www.fordservicecontent.com/Ford_Content/vdirsnet/workshop/ody/~WSKG/US/EN/... 1/9/2019

    You might also like