Tiri Stores

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

Hernández Pérez Aldo Samuel 6AM2

1. What meaning SCR?

R= Semiconductor-controlled rectifiers

2. what does this figure represent?

R= It is essentially the symbol for a diode (or rectifier)

3. what is 𝑉𝑅𝑊𝑀 ?

R= is the maximum reverse working voltage for a thyristor

4. What is the maximum reverse working voltage of a thyristor?


R= 7000 V.
5. In the on state, a high-power thyristor conducts currents with a average. what is the
average?

R=2000-3000 A

6. What is the maximum junction temperature for thystors specified by most manufacturers?

R= 125 ͦC

7. What is a thyristor?

R= The thyristor is a minority carrier device and has the highest blocking voltage capabilities as
well as the largest current carrying capabilities of all solid state switching devices.

8. what happen if in the equation 𝛼1 + 𝛼1 approaches


the unit?

R= the anode current will be arbitrarily big. the thyristor will be at the conductive transition point
where it is about to go to negative resistance state.

9. what happens when the thyristor is high?

R= In the active state there is a strong injection of minority carriers in the four zones of the
thyristor structure.
Hernández Pérez Aldo Samuel 6AM2

10. what happens once the thyristor is latched in the on state?

R= the gate terminal no longer has control over the state of the device. In particular, the gate
cannot be used to turn off the thyristor.

11. How does it turn off?

R= Shutdown is only effected by the external circuit, by reducing the anode current to below the
holding current for a specified minimum period.

12. what does the thyristor turn-off require?

R= reverse biased by the external circuit for a minimum period.

13. What happens if the speed marked on the specification sheet of the thyristor is exceeded?

R= If the speed marked on the specification sheet is exceeded there is damage to the thyristor, this
damage can occur because the high current growth rates mean that the rise time will be short and
therefore the lit area around the zone of the thyristor gate will be very small at the end of the rise
interval compared to the cross-sectional area of the device

14. How is a thyristor built?

R= The thyristor has a unique four-layer construction of alternating p-type and n-type zones.

15. In what cases is a thyristor used?

R= It is often used with lower switching frequencies due to the long lifetimes used for low on-
state losses and due to the large amount of charge stored.

You might also like