Wireless Smart Otoscope: FCC Warning: Quick Start Guide Product Size Fault Analysis and Troubleshooting

Download as pdf or txt
Download as pdf or txt
You are on page 1of 1

Quick start guide 3.Install the earpick firmly on the otoscope 6.

all the earpick firmly on the otoscope 6.The inside of the ear can be observed in Product size Fault analysis and troubleshooting FCC WARNING:
tip when you need to pick your ear (If you real time by the App.And the transparent Faults Solution
purchased one with a base, please open earpick won’t block your view. Try the correct boot method a few more Note: This equipment has been tested and found to
the base and select the appropriate ear No response on startup.
time.
comply with the limits for a Class B digital device,
1.Scan QR Code to download app. Please charge with a matching charging
spoon) cable for 1hour, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against

130.35 mm
Camera doesn't light. Shutdown and restart the otoscope.

128mm
Uninstall the existing APP and rescan harmful interference in a residential installation. This
App crashing.
the QR code for installation.
equipment generates uses and can radiate radio
There is not enough electricity.please use
Power indicator light
the the matching charging cable for charging,
frequency energy and, if not installed and used in
flashes.
and the charging time is 1 hour. accordance with the instructions, may cause harmful
The product failed to
Disconnect the phone from the otoscope interference to radio communications. However, there
properly display real-time
images after successfully
WiFi, restart the otoscope, and is no guarantee that interference will not occur in a
reconnect the WiFi.
connecting to APP.
15 mm 15mm
particular installation. If this equipment does cause
Wireless 4.Connect product WiFi:weiview-xxx. 7.Screen lock is designed to avoid (T1) (T2) The WiFi connection is
unstable and sometimes
Restart the otoscope and reconnect the harmful interference to radio or television reception,
App
misoperation of children. disconnected in seconds. which can be determined by turning the equipment off
smart otoscope Product parameters If the above operation fails to solve the problem, please contact
customer service, we will further provide you with a practical solution,
and on, the user is encouraged to try to correct the
interference by one or more of the following
Product name: Wireless Smart Otoscope Notes measures:
2.Remove the lid and the otoscope will be 1. Please observe the surroundings before use , and don't use the
Product Model: T1 T2 -Reorient or relocate the receiving antenna.
power on automatically. product while running to avoid impact.
2. Before use , be sure to install a protective pear-picking rod and fasten -Increase the separation between the equipment and
Image transfer rate: 25fps the head of the ear-picking rod to protect your ears. receiver.
3. This product is not suitable for children under 6 years old.
Image transmitter: CMOS 4. It is prohibited for children to use this product alone to avoid careless -Connect the equipment into an outlet on a circuit
harm. different from that to which the receiver is connected.
Operating ambient temperature: -10~50°C 5. Please store the product in the normal temperature and avoid direct
-Consult the dealer or an experienced radio/TV
5.Return to the App then click “start” to sunlight to avoid product damage.

inspect ear. Battery type: Lithium battery 6. The APP can not compatible with Samsung S7. technician for help.
7. When cleaning the lens , please wipe carefully with the professional
* RF warning for Portable device:
Battery life: approx 1 hour alcohol cotton swab provided
8. In order to ensure the best use experience, please keep the child in a The device has been evaluated to meet general RF
8.Low battery alert. Charging time: 1 hour seated position and operate the product horizontally when picking the exposure requirement. The device can be used in
ear for the child .
portable exposure condition without restriction.
Input current: DC 5V 300ma 9. FCC statement: This device complies with Part 15 of the FCC rules.

Professional Otoscope Operation is subject to the following two conditions: This device complies with part 15 of the FCC Rules.
When the battery is low, the red light Probe diameter: 3.9mm 1)This device may not cause harmful interface;
Operation is subject to the following two conditions:
Otoscope General Manual flashes,please charge in time 2)This device must accept any interference received, including
(1) This device may not cause harmful interference,
Optimnm focal length: 1.0-1.5cm interference that may cause undesired operation.
10. ROHS compliance: This product is in compliance with Directive and (2) this device must accept any interference
Otoscope power-on prompt light is
green
Gravity sensor: 3 Axis Gyro 2011/65/EU of the European Parliament and of the Council of 8 June
2011 on the restriction of the use of certain hazardous substances in received, including interference that may cause
electrical and electronic equipment. undesired operation.

You might also like