Scribd Logo
Upload

Welcome to Scribd!

  • 63 views

    Electrical Installation Level 1 - Cluster 1 - Archerneil Stephens and Yohance Ford - Winston Jones High MOE

    Uploaded by

    Guyan Gordon
    The document describes a project where students wired a three way light circuit controlling two parallel lamps from three switches along with two 110V outlets. They designed the circuit, connected the components using trunking, conduit and sheathed cable according to Jamaica standards, installed circuit breakers, and tested the circuit.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Electrical Installation Level 1 - Cluster 1 - Archerneil Stephens and Yohance Ford - Winston Jones High MOE

    Uploaded by

    Guyan Gordon
    63 views2 pages
    The document describes a project where students wired a three way light circuit controlling two parallel lamps from three switches along with two 110V outlets. They designed the circuit, connected the components using trunking, conduit and sheathed cable according to Jamaica standards, installed circuit breakers, and tested the circuit.

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    The document describes a project where students wired a three way light circuit controlling two parallel lamps from three switches along with two 110V outlets. They designed the circuit, connected the components using trunking, conduit and sheathed cable according to Jamaica standards, installed circuit breakers, and tested the circuit.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    63 views2 pages

    Electrical Installation Level 1 - Cluster 1 - Archerneil Stephens and Yohance Ford - Winston Jones High MOE

    Uploaded by

    Guyan Gordon
    The document describes a project where students wired a three way light circuit controlling two parallel lamps from three switches along with two 110V outlets. They designed the circuit, connected the components using trunking, conduit and sheathed cable according to Jamaica standards, installed circuit breakers, and tested the circuit.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    You are on page 1of 2

    CARIBBEAN VOCATIONAL QUALIFICATION (CVQ)

    ELECTRICAL INSTALLATION LEVEL 1 (MEM11002V03)


    CLUSTER 1
    CIRCUIT OPERATION REPORT

    CANDIDATES’ NAMES Yohance Ford - 2200461335


    Archerneil Stephens - 2200461336
    INTRODUCTION

    We wired a three way control of 2 lamps in parallel and two 110V outlets using trunking, conduit

    and sheathed cable. The circuit was wired using the Jamaica Standard Regulations.

    The following tasks were carried out:

    a. Design a 3 way control lighting circuit.

    b. Connect a 3 110V light circuit controlling two lamps in parallel, using 2 two – way

    switches and an intermediate switch.

    c. Wire two (2) general purpose 110V/5A outlets

    d. Install circuit breakers to control each circuits.

    e. Test circuit and submit for evaluation.

    Circuit Operation

    1. The circuit was connected so that the two lamps connected can be controlled from three

    (3) different switching points, using one four way switch and 2 two way switches.

    2. The plug outlets circuit was connected according to Jamaica Standard Regulations.

    3. The two lamps were protected by a 15A single pole circuit breaker.

    4. The plug circuit was protected 20 A single pole breaker.

    5. A 40 A double pole circuit breaker was used to protect the entire circuit.

    You might also like