Scribd
Upload
189 views1 page

EeePC Hack withinCF (E)

The document discusses modifying an EeePC laptop to use a compact flash (CF) card or solid state drive (SSD) instead of the default hard drive. It provides wiring diagrams showing how to connect the CF/SSD to the EeePC's FLASH_CON connector by using a CF to IDE adapter. Instructions are given for installing a switch to select whether the CF or SSD acts as the master device.

Uploaded by

amostori
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
189 views1 page

EeePC Hack withinCF (E)

The document discusses modifying an EeePC laptop to use a compact flash (CF) card or solid state drive (SSD) instead of the default hard drive. It provides wiring diagrams showing how to connect the CF/SSD to the EeePC's FLASH_CON connector by using a CF to IDE adapter. Instructions are given for installing a switch to select whether the CF or SSD acts as the master device.

Uploaded by

amostori
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

EeePC connector

FLASH_CON
2

EeePC FLASH_CON 1 D0 3 D1 5 D2 7 D3 9 GND 11 D4 13 D5 15 GND 17 19 21 23 25 27 29 31 33 35 37 39 41 43 45 47 49 51 D6 D7 GND PERn0 ??? PERp0 ??? GND GND PETn0 ??? PETp0 ??? GND A00 A01 A02 N.C. PDIAG 3.3V 3.3V 3.3V

2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 42 44 46 48 50 52

D15 GND D14 D13 D12 D11 D10 D9 GND D8 RESET IOWR GND IORD REG(DMAACK) INPACK(DMARQ) GND USB_DUSB_D+ GND IORDY INTRQ CS0 CS1 GND DASP

Note : - Please check wiring well and do not neglect a check with a tester. - Make the length of wiring as the same as possible. - Recommend that wiring of a power supply and GND uses thick wiring. A problem peculiar to an adapter - A conversion adapter should use the thing corresponding to DMA. In the case of a PIO mode, patterns may differ. - When recognition does not go well, it may be necessary to remove the LED relation of a DASP signal.

EeePC(SSD) modification

SSD CSEL

CF CSEL

GND

5 10 15 20 25 30 35 40 45 50
*gray is GND.

Let s enjoy EeePC Hacking!!


EeePC Hack with in Compact Flash
A plan, data creation : mao A check of operation : mao & tie2 PDF creation : tie2 first appearance: 2008.03.09 translation&fix: 2008.03.15

CF-IDE Adapter
Pin 1 of 40(or 44) IDE

-RESET(22) D7(19) D6(17) D5(13) D4(11) D3(7) D2(5) D1(3) D0(1) GND DMARQ(32) -IOIWR(24) -IORD(28) IORDY(42) -DMACK(30) INTRQ(44) A01(39) A00(37) -CS0(46) -DASP(52) +5V(51) GND

GND D8(20) D9(16) D10(14) D11(12) D12(10) D13(8) D14(6) D15(2) KEY(NC) GND GND GND CSEL(no use) GND -IOCS16(open) -PDIAG(45) A02(41) -CS1(48) GND +5V(49) NC

IDE(3.5 or 2.5) to FLASH_CON Pin Name Type FLASH_CON Comment 1 -RESET I 22 3 D7 I/O 19 5 D6 I/O 17 7 D5 I/O 13 9 D4 I/O 11 11 D3 I/O 7 13 D2 I/O 5 15 D1 I/O 17 D0 I/O 19 GND 21 DMARQ 23 -IOWR I 25 -IORD I 27 IORDY O 29 -DMACK 31 INTRQ O 33 A01 I 35 A00 I 37 -CS0 I 39 -DASP I/O The following is only 2.5 41 +5V 43 GND 3 1 32 24 28 42 30 44 39 37 46 52 51

Pin 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 42 44

Name GND D8 D9 D10 D11 D12 D13 D14 D15 KEY(NC) GND GND GND CSEL GND -IOCS16 -PDIAG A02 -CS1 GND +5V NC

Type I/O I/O I/O I/O I/O I/O I/O I/O I O I/O I I

FLASH_CON Comment **2 20 16 14 12 10 8 6 2

**2 CF to 43pin

CF to 44pin

45 41 48 49

**2 **2 **2 **1 **2

**2 CF to 3.3V

CF to 3.3V **2

( )The number is pins of FLASH_CON.

**1 : no use.Master/Slave is switched on PCB. **2 : If GND is connected by CF-IDE PCB, wiring is good at two. Because, it is since +5V is two.

The chip resistance is removed, and the cable is connected.

CSEL(CF:39) GND CSEL

example:installing switch
BlueCF CSEL

BlackGND

CSEL:Switch of Master/Slave Master : GND Slave : Open

WhiteSSD CSEL

It is also possible for Master/Slave to change with the slide switch and this toggle switch of 1 circuit 2 point of contact. In the case of an example, CF is Master. If it slides, SSD can be changed to Master.

You might also like