Scribd
Upload
66 views3 pages

Service Bulletin: Issued by Canon Europa N.V

This service bulletin from Canon addresses an issue where removing a fan duct from copier models iR5570 and iR6570 could cause too much stress on a connector, leading to a cable break and error code. To prevent this, a new fan connecting cable part is introduced that makes disconnecting the fan relay connector easier. Technicians are instructed to add this new cable by connecting it between the front cable and fan relay cable inside the machine. This improves the cable connection and prevents cable breaks when removing the fan duct.

Uploaded by

okeinfo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
66 views3 pages

Service Bulletin: Issued by Canon Europa N.V

This service bulletin from Canon addresses an issue where removing a fan duct from copier models iR5570 and iR6570 could cause too much stress on a connector, leading to a cable break and error code. To prevent this, a new fan connecting cable part is introduced that makes disconnecting the fan relay connector easier. Technicians are instructed to add this new cable by connecting it between the front cable and fan relay cable inside the machine. This improves the cable connection and prevents cable breaks when removing the fan duct.

Uploaded by

okeinfo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Service Bulletin

Copier B/W
Issued by Canon Europa N.V.
Hardware

Model: Ref No.:


iR6570-027
iR5570
(F1-T01-0M5-10069-01)
iR6570
Date:
March, 2007

Location:
Machine Font Plate
Subject:
Preventing the error code "E824" resulted from a break in the Front Cable
Detail:
When removing the Primary Fan Duct [1], a Relay Connector connected to the Primary Fan is hard to be
disconnected, consequently applying too much load to J161D Connector [2] of the Front Cable. This, in some cases,
causes a break in the Cable, ultimately leading to the error code "E824" (Primary Charging Cooling Fan error). To
prevent this, the Fan Connecting Cable is added to facilitate connection/ disconnection of the Reply Connector.

P-1 Host machine front area

[1] Primary Fan Duct

[2] J161D Connector

<Factory measures>
Not executed due to production end.

(1/3)
iR6570-027
Servicing work:
To prevent the aforementioned symptom, add the Fan Connecting Cable that is newly set up as a service part by the
following procedure:
1) Open the front Cover.
2) Open the Toner Cover.
3) Remove the 2 screws and detach the Toner Supply Cover.
4) Remove the screw and detach the Connector Cover.
5) Connect the Fan Connecting Cable [2] to the Front Cable [1], (P-2).
Note: Be sure to place the whole Cable into the space so as to prevent it from being trapped by the Connector Cover
[3], (P-3).
6) Follow the reverse order to attach all the parts removed.

P-2 Enlarged figure at Cable connection

[1] Front Cable

[2] Fan Connecting Cable

P-3 Fan Relay Cable arrangement

[3] Connector Cover

(2/3)
iR6570-027
Service parts:

Parts Number Description Q'ty P.C. page

Old

CABLE, FAN 101


New FM3-0074-000 0->1
CONNECTING

(3/3)

You might also like