NLV8.4F Variable Speed Drive Compressor R134a 115-127V 50-60Hz
NLV8.4F Variable Speed Drive Compressor R134a 115-127V 50-60Hz
NLV8.4F Variable Speed Drive Compressor R134a 115-127V 50-60Hz
4F
Variable Speed Drive Compressor
R134a
115-127V 50-60Hz
General
Code number compressor (without electronic unit) 105G5960
Code number electronic unit 105N4212
Approvals UL984
Compressors on pallet 80
Application
Application LBP/MBP
Frequency Hz 50 60
Evaporating temperature °F -31 to 45 -31 to 45
Voltage range V 80 - 140 80 - 140
Max. condensing temperature continuous (short) °F 140 (158) 140 (158)
Max. winding temperature continuous (short) °F 257 (275) 257 (275)
Cooling requirements
Frequency Hz 50 60
Application LBP MBP HBP LBP MBP HBP S = Static cooling normally sufficient
O = Oil cooling
90°F F2 F2 – F2 F2 –
F1 = Fan cooling 1.5 m/s
100°F F2 F2 – F2 F2 – (compressor compartment temperature
110°F F2 F2 – F2 F2 – equal to ambient temperature)
Remarks on application: F2 = Fan cooling 3.0 m/s necessary
Features SG = Suction gas cooling normally sufficent
– = not applicable in this area
Speed range rpm 2000 - 4000
Control modes with - mech. thermostat 115V ON/OFF
integrated speed control AEO*) - 5V DC ON/OFF
External speed control - 5V DC 200-400Hz
Protections - current
- speed
- temperature
*) AEO - Adaptive Energy Optimizer
Motor
Motor type permanent magnet
LRA (rated after 4 sec. UL984), HST A electronic cut-off
Cut in Current, HST A 6
Resistance, all 3 windings (77°F) Ω 2.0
Design
Displacement cu.in 0.51
Oil quantity (type) fl.oz. 10.8 (polyolester)
Maximum refrigerant charge oz. 14.0
Free gas volume in compressor fl.oz. 79.7
Weight: Compressor / Electronic unit lbs. 23.8 / 1.3
Dimensions
Height inch A 7.99
B 7.76
B1 –
B2 –
Suction connector location, I.D. in. | angle C 0.320-0.327 | 15°
material | comment Copper | Rubber plug
Process connector location, I.D. in. | angle D 0.252-0.259 | 25°
material | comment Copper | Rubber plug
Discharge connector location, I.D. in. | angle E 0.252-0.259 | 35°
material | comment Copper | Rubber plug
Oil cooler connector location, I.D. in. | angle F –
material | comment –
Remarks:
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed.
All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.