IKALAT NYO LAGYAN NYO TANONG AT SAGOT

Pahelp dito sa 1 di ko alam ano sagot hahaha

Electrical ___ is the property of a material that limits the amount of flow of current
and converts electric energy to heat energy. ANS: RESISTANCE

ANS: SERVICE DROP

Electrical ___ is the property of a material that limits the amount of flow of current
and converts electric energy to heat energy.

potential difference
 current

resistance

wire

Given Ra = 7 ohms, Rb = 6 ohms, Rc = 3 ohms and Rd = 6 ohms, find the equivalent

resistance at terminals a-b. 3.7 ohms?????

conductor is known as hot or live conductor because it feeds current to the circuit.
ANS. UNGROUNDED

It is a collection of electrical elements interconnected in some specific way through which electric
current flows or is intended to flow.
ANS. Electric Circuit

In a series circuit all the resistances will have the same ___. ANS: CURRENT

It is a male connecting device that has two or more prongs that are inserted into a receptacle to
connect to an electrical circuit.
ANS. PLUG

The following 4 resistors are in series: 9 Ohms, 23 Ohms, 14.4Ohms and 5 Ohms. If the voltage
across 5 Ohms is 18 Volts, determine the total voltage (in Volts) applied to the circuit. (Unit is not
required. Round off the answer to whole number.)
ANS: 185 (not sure pa) Paverify if may time kau hehez TAMA PO HEHE←thankss
hehezxzzzxxzzzxsss
Letter code that means MAXIMUM ALLOWABLE TEMPERATURE OF 90ºC.

HH

The middle letters (HH) indicate it's high heat resistance, suitable for
high-temperature use up to 90 degrees Celsius

It shows a comprehensive interconnection, size and rating of the service drop/lateral, service
entrance,service equipment,feeder, subfeeders, load centers, and panelboard.Riser diagram
it is a broad category of electrical or electronic machine or instrument designed to perform a specific
mechanical, chemical, heating, or lighting function through the use of electrical energy.Utilization
equipment

Not sure paverify : ans = 8

Low voltage systems carry voltages less than ____.
ANS. 600v
A common rule of thumb is that anything below 600 volts is considered low voltage.
It is a device designed to open (or trip) and close a circuit by non-automatic means and
to open the circuit automatically on a predetermined overcurrent without damage to itself
when properly applied within its rating

resistor

fuse

switch

circuit breaker

_______ voltage is the highest voltage to which a wiring device can be exposed.
Ans. Maximum

It is the maximum current a conductor can carry continuously without exceeding the temperature
limitations of the insulation and sheathing material.

trip rate

ampacity

voltage

AWG

It is a device designed to open (or trip) and close a circuit by non-automatic means and to open the
circuit automatically on a predetermined overcurrent without damage to itself when properly applied
within its rating ans.circuit breaker

_____ conductor is known as hot or live conductor because it feeds current to the circuit.
Ans. Ungrounded

It shows a comprehensive interconnection, size and rating of the service drop/lateral, service
entrance,service equipment,feeder, subfeeders, load centers, and panelboard.

riser diagram

symbols

branch circuit

load schedule

The following 4 resistors are in series: 10 Ohms, 19 Ohms, 9.4Ohms and 5 Ohms. If the voltage
across 5 Ohms is 19 Volts, determine the total voltage (in Volts) applied to the circuit. (Unit is not
required. Round off the answer to whole number.

Given Ra = 7 ohms, Rb = 7 ohms, Rc = 2 ohms and Rd = 5 ohms, find the equivalent

resistance at terminals a-b.

ANS:1.19? ←di ko ren sure eh, compute ko ulet hehe

Ano po sol here
It is a set of fuses or a circuit breaker that protects the service entrance conductors.

service disconnect

It is a broad category of electrical or electronic machine or instrument designed to perform a specific

mechanical, chemical, heating, or lighting function through the use of electrical energy.

electrical device

outlet

utilization equipment

Transformer
Type letter ____ means MOISTURE - RESISTANT THERMOPLASTIC.

THHN

RHW

THHW

TW

An _______ specifies the minimum provisions necessar for protecting people and property from the
improper use of electricity and electrical equipment.

electrical code

electrical license

panelboard
 electrical code

electrical permit

These devices safeguard the building service or an individual circuit from excessive current flows.

switches

overcurrent protection

outlets

service drop

The total resistance of 4 resistors connected in parallel is 1.5 Ω. The resistances are 15 Ω, 6 Ω, 3 Ω,
and an unknown R. Calculate R (in Ω). (Unit is not required) 10 ohms OMCM TENKYU HEHEHHE

Equation na ginamit ko: 1.5=1/[(1/15)+(⅙)+(⅓)+(1/R)]

Electrical _____ are materials that allow the essentially free passage of current when
connected to a battery or other source of electrical energy.
semi conductors

inductors

insulators

conductors

A conductor encased within material of composition or thickness that is not recognized by the PEC as
electrical insulation
Ans.covered
It is the rate electric energy is converted into another form, such as light, heat or
mechanical energy (or converted from another form into electrical energy).
Electrical voltage

Electrical power
eto answer
no????

Electrical circuit

Electrical cost

It is a male connecting device that has two or more prongs that are inserted into a receptacle to
connect to an electrical circuit.

receptacle

plug

appliance

outlet

Ten
15-Ohm resistances are in parallel. What is the total resistance? (Use 1 decimal place. Unit is not
required.)
ANS: 1.5

The AWG number of a conductor is proportional to the cross section diameter of the wire.
True
False<3
____ circuit is an uninterrupted path that allows a continuous flow of current through
an electrical circuit.

Short

Open

Closed

Parallel

Electrical ___ is the motion or transfer of charges from one region of a conductor to
another.
voltage

circuit

current

Resistor
 Current
ata meron
na yan sa
taas

PAHELP PO DITO PLS TENCHU

The fo

I=V/R I=13/7+3 = 1.3 I think

Pano soln neto

Meron po kayo here?
Ten identical 49-Ohm resistances are in parallel. What is the total resistance? (Use 1 decimal
place. Unit is not required.) Rt=R/n ; 49/10=4.9

Pahelp any idea pano makuha?thanksxszzs

The following resistors are in parallel: 6 ohms and 3 ohms. If the circuit's voltage source is
27V, what is the power (in Watts) absorbed by the 6-ohm resistor. (Unit is not required.
Use 2 decimal places.) PAHELP PO DITO PLS meron na po ata sa taas hihi
hehesxsxzsxszxzzxs HUHU IBA PO YUN