Scribd
Upload
44 views

Module 14

Uploaded by

midun
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
44 views

Module 14

Uploaded by

midun
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Module 14.

Propulsion

1) A fuel flow transmitter requires a motor or a synchronous motor to have a


•  constant voltage within small tolerances
•  constant frequency within small tolerances
•  low EMF as it is immersed in fuel

2) An increase in fuel flow through the impeller type fuel flow transmitter is measured by
•  drum lags impeller
•  impeller lags turbine
•  decreasing angle between the two

3) An aircraft flying at 800mph would typically use


•  turbojet
•  turbofan
•  turboprop

4) A thermocouple indication is taken from the


•  hot junction
•  cold junction
•  difference between the hot junction and the cold junction

5) An EPR system reads slightly over 1, this would mean


•  the transmitter datum point has moved and needs replacing
•  no action required this is normal
•  the indicator needs re-calibrating back to 1

6) Propeller torque is analogous to


•  engine RPM
•  shaft horsepower
•  propeller RPM

7) The variable bleed valves on a engine at start up is


•  open
•  closed
•  modulating

8) The fuel metering unit has direct inputs via


•  only the EEC
•  the EEC and the fire control handle
•  the EEC, fire control handle and the engine master switch

9) When using a test set to test an EGT thermocouple circuit


•  no compensation for ambient temperature is required
•  only consider ambient temperature compensation if the ambient temperature is over 20oC
•  always compensate for ambient temperature
10) EPR is a ratio of

•  P1 to P4
•  P1 to Pfan
•  P1 to P6

11) in a flow type fuel system, fuel shutoff is done by


•  mechanical ball valve
•  fcu torque motor
•  l.p fuel cock

12) How is fuel flow varied in a variable displacement pressure type pump?
•  Alter the camplate angle
•  Remote servo pressure
•  Direct cable to camplate

13) A short circuit in a d.c ratiometer will give


•  max scale reading
•  zero scale reading
•  min scale reading

14) Propeller speed is measured from


•  a slip ring pulse probe
•  a tachometer on the LP turbine shaft
•  a pulse probe at the engine side of the reduction gear

15) How are the combustion chambers cooled?


•  By l.p compressor air
•  By h.p compressor air
•  By fan pressure air

16) Oil systems consists of


•  2 systems
•  3 systems
•  4 systems

17) The inlet of a turbo fan is


•  divergent
•  convergent
•  convergent-divergent

18) Manifold pressure is measured


•  at inlet port above and below ambient conditions
•  at inlet port above and below standard atmosphere at sea level
•  at inlet port indicating boost pressure

19) When using a test set to test an EGT thermocouple circuit


•  no compensation for ambient temperature is required
•  only consider ambient temperature compensation if the ambient temperature is over 20oC
•  always compensate for ambient temperature

20) The inlet of a turbo fan is


•  divergent
•  convergent
•  convergent-divergent

You might also like