WD-A-CC Series Product Specifications
WD-A-CC Series Product Specifications
Sun Well Solar Corporation
220, Wen-Huah 2nd Road, Kwei-Shan, Tao-Yuan, 333 Taiwan
TEL：+886-3-2550250
FAX：+886-3-3186669
Sun Well Solar Corp. 2008. All rights reserved 1
WD-A-CC Series Product Specifications
Product Specifications
1. WD-A-CC Series Module Specifications
Table1. Physical Specifications
Property Specification
Active Material of Cell Amorphous silicon
Junction Type of Cell Single-junction
Material for Encapsulation Polyvinylbutyral (PVB), thickness: 0.76mm
Front Cover Float glass, thickness: 3.2 mm
Back Cover Tempered float glass, thickness: 3.2 mm
Wiring Material Tin & silver coated copper ribbon, thickness: 0.1 mm
Junction Box / IP Class Multi-Contact PV-JB-LC-2 / IP 65
Junction Box Cable Length 800 mm x 2
Rated voltage： 1000V D.C.
Temperature range： -40 to 90℃
Connecting Cable/Plug
Plug/Socket type： Ø 4mm
Cable cross section：2.5mm2
See-through No
Frame No
Length 1300 mm +2/-1mm
Dimensions Width 1100 mm +2/-1mm
7.0 ± 0.5 mm (without junction box)
Thickness
21.2 ± 1.0 mm (with junction box)
Weight 24.0 ± 0.5 Kg
Table 2. Certifications
Certifications
EN/IEC 61646
Certifications EN/IEC 61730 application Class A
Class C fire rating
Remark:
1. The module is tested under 2400Pa (50 lb/ft2) mechanical load or approximately to a
wind speed of 130 km/h (80 mph).
Sun Well Solar Corp. 2008. All rights reserved 2
WD-A-CC Series Product Specifications
Table3. Electrical Specifications
Property Specification
Max. System Voltage 1000 Volt D.C.
Isc: +0.04 %/K
Voc: -0.28 %/K
Temperature Coefficients
Pmpp: -0.21 %/K
Vmpp: -0.28 %/K
Maximum Over-current Protection Rating 2A
Stabilized Initial
Module Power Performance at STC Performance at STC
classification Class Vmpp Impp Voc Isc Vmpp Impp Voc Isc
[V] [A] [V] [A] [V] [A] [V] [A]
WD-A-CC-087-40 75 W 97 0.78 131 0.97 103 0.90 136 1.03
WD-A-CC-087-30 80 W 100 0.80 134 1.00 106 0.93 139 1.06
WD-A-CC-087-20 85 W 103 0.83 137 1.05 110 1.00 141 1.11
WD-A-CC-087-10 90 W 106 0.86 140 1.08 112 1.10 144 1.16
With +10%/-5% tolerance
Remarks:
1. The modules electrical ratings are measured under Standard Test Conditions (STC) and have
been delivered on the specific table of electrical characteristics as shown above.
2. A photovoltaic module may produce more current and/or voltage than reported at STC.
Sunny, cool weather and reflection from snow or water can increase current and power
output. Therefore, the values of Isc and Voc marked on the modules should be multiplied by
a factor of 1.25 when determining component voltage ratings, conductor ampacities, fuse
sizes, and size of controls connected to PV output.
。
3. [STC]: 1000 W/m2, AM 1.5, 25 C
4. The exactly measured electrical characteristics are shown on the label at rear side of the
modules.
Sun Well Solar Corp. 2008. All rights reserved 3
WD-A-CC Series Product Specifications
3. Dimensions and Drawing
Refer to the following diagram.
4. Standard operating conditions
The modules should operate under sufficient sunlight and subjected to seawater or
snowfall (1 m or more) should be avoided. Ambient temperature should be in the range
between -20 °C and 45 °C. The modules can be installed either vertically or
horizontally and must be securely fixed. The junction box is qualified for IP65 of IEC
60529; however, water accumulating on the junction box or being immersed in water
should be avoided.
5 .Warranty
Product Guarantee Power Guarantee
(Workmanship/ Material) (Pmax output)
90% of the specified minimum output of the
module for a 10-year period, 80% of the
2 years after the shipment from SWS
specified minimum output of the module for a
20-year period after shipment from SWS.
Sun Well Solar Corp. 2008. All rights reserved 4
WD-A-CC Series Product Specifications
5. Performance characteristics.
I. WD-A-CC-087-40
WD-A-CC-087-40 Initial Performance
WD-A-CC-087-40 Stabilized Performance
1.4
1.2
Module Current (A)
0.8
0.6
0.4
0.2
0
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
Module Voltage (V)
WD-A-CC-087-40 Initial Performance
WD-A-CC-087-40 Stabilized Performance
140
130
120
110
Out Put Power (W)
100
90
80
70
60
50
40
30
20
10
0
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
Module Voltage (V)
Sun Well Solar Corp. 2008. All rights reserved 5
WD-A-CC Series Product Specifications
II. WD-A-CC-087-30
WD-A-CC 087-30 Initial Performance
WD-A-CC 087-30 Stabilized Performance
1.4
1.2
Module Current (A)
0.8
0.6
0.4
0.2
0
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
Module Voltage (V)
WD-A-CC-087-30 Initial Performance
WD-A-CC-087-30 Stabilized performance
140
130
120
110
Out Put Power (W)
100
90
80
70
60
50
40
30
20
10
0
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
Module Voltage (V)
Sun Well Solar Corp. 2008. All rights reserved 6
WD-A-CC Series Product Specifications
III. WD-A-CC-087-20
WD-A-CC-087-20 Initial Performance
WD-A-CC-087-20 Stabilized Performance
1.4
1.2
Module Current (A)
0.8
0.6
0.4
0.2
0
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
Module Voltage (V)
WD-A-CC-087-20 Initial Performance
WD-A-CC-087-20 Stabilized Performance
140
130
120
110
Out Put Power (W)
100
90
80
70
60
50
40
30
20
10
0
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
Module Voltage (V)
Sun Well Solar Corp. 2008. All rights reserved 7
WD-A-CC Series Product Specifications
IV. WD-A-CC-087-10
WD-A-CC-087-10 Initial Performance
WD-A-CC-087-10 Stabilized Performance
1.4
1.2
Module Current (A)
0.8
0.6
0.4
0.2
0
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
Module Voltage (V)
WD-A-CC-087-10 Initial Performance
WD-A-CC-087-10 Stabilized Performance
140
130
120
110
Out Put Power (W)
100
90
80
70
60
50
40
30
20
10
0
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
Module Voltage (V)
Sun Well Solar Corp. 2008. All rights reserved 8
WD-A-CC Series Product Specifications
V. Temperature Coefficient of WD-A-CC Series Modules
105
Relative Value (%)
100
95
Isc (Coeff.= 0.04%)
Voc (Coeff. = -0.28%)
90
FF (Coeff. = 0.00%)
Pmax (Coeff. = -0.21%)
85
0 10 20 30 40 50 60 70 80
Module Temperature (℃ )
Sun Well Solar Corp. 2008. All rights reserved 9
