A B C A B C M FEEDER CONDUCTOR FROM BUS

WIRE
SINGLE PHASE, 230 V (LINE TO
GROUND SYSTEM)

2 - 14mm² THWN CU WIRE

3 3
h g h g
TOILET S-g,h TOILET S-g,h

40 AT
d e e e
OFFICE SPACE
COMMERCIAL SPACE
LO 1 15AT 15AT 2 LO

S-d,e,f
CO 3 20AT 20AT 4 SPARE
2 d
S-d,e,f
e
2 d d

S-a,b,c
c c f c c f
OFFICE SPACE
COMMERCIAL SPACE
9
8
7
SINGLE LINE DIAGRAM - GROUND FLOOR
b b 6 LP-GF b b LP-SF
5 2 2
4
3
ELECTRICAL SPECIFICATIONS
S-a,b,c S-a,b,c
2
1 a a
1
up 1 a a
1. ALL ELECTRICAL WORKS SHALL CONFORM TO THE NEW RULES AND REGULATIONS OF THE
NATIONAL ELECTRICAL CODE OF THE PHILIPPINES, CITY ORDINANCES AND ELECTRIC UTILITY
C A N O P Y

2. ALL ELECTRICAL INSTALLATIONS SHALL BE DONE UNDER THE SUPERVISION OF A DULY

LP-SF
SECOND FLOOR 1
LICENSED ELECTRICAL ENGINEER.
FIRST FLOOR LP-GF E-1 LIGHTING LAYOUT 3. ALL WIRING EQUIPMENT AND FIXTURES SHALL BE BRAND NEW AND SHALL CONFORM TO THE
E-1 LIGHTING LAYOUT 1 1 2 SCALE 1 : 100 MM STANDARD OF THE BUREAU OF PRODUCT STANDARDS OR UL LISTED PRODUCTS.
1 2 SCALE 1 : 100 MM
4. UNLESS OTHERWISE INDICATED IN THE PLAN, ALL CONVENIENCE OUTLET SHALL BE
SCHEDULE OF LOAD - GROUND FLOOR PLACED 0.30 METERS ABOVE FLOOR LEVEL.
CKT. NO. LOAD DESCRIPTION VA VOLT AMP CIRCUIT BREAKER SIZE OF WIRE SIZE OF CONDUIT
5. USE CAST ALLOY FITTINGS OF PROPER TYPE FOR ALL OUTLETS ON EXPOSED CONDUIT
1 6-50W ENERGY SAVER LAMP 300 230 1.304 15 AT 2 - 3.5mm² THWN 13mmØ PVC PIPE WORK AND WEATHERPROOF INSTALLATIONS.
2 7-50W ENERGY SAVER LAMP 350 230 1.522 15 AT 2 - 3.5mm² THWN 13mmØ PVC PIPE
6. MAKE ALL WIRES CONTINUOUS BETWEEN OUTLETS OR FROM PANEL TO OUTLETS.
3 7-180VA DUPLEX CON. OUTLET 1260 230 5.478 20 AT 2 - 5.5mm² THWN 13mmØ PVC PIPE

8 SPARE - 230 - 20 AT 2 - 5.5mm² THWN 13mmØ PVC PIPE

7. PROVIDE A SEPARATE SERVICE DROP FOR THE BUILDING'S ELECTRICAL WIRINGS.

TOTAL 1910 8.304 8. SERVICE ENTRANCE CONDUCTOR SHALL BE INSTALLED IN FREE OR WITH A TEMPERATURE
lW = (l T x Demand Factor of 80%) + 25% LARGEST MOTOR LOAD
RATING OF 75 DEGREE CELCIUS
lW = (8.304 x 0.8) + (0.25 x 5.478) = 8.0127 Amps USE 2 - 14mm² THWN CU WIRE IN 25mmØ IMC
9. ALL WIRINGS SHALL BE CAREFULLY INSPECTED AND APPROVED BY A COMPETENT
l CB = (l W + 250% LARGEST MOTOR LOAD ELECTRICAL INSPECTOR BEFORE THE CURRENT IS TURNED ON, AND AN APPROVAL BY THE
l CB = 6.6432 + (2.5 x 5.478) = 20.3382 Amps USE 40 AT MAIN, 230 VOLTS, 2P, 60 HZ FIRE DEPARTMENT IS NEEDED.

PREPARED BY: PRC REG. NO.: PROJECT TITLE AND LOCATION: APPROVED : SHEET CONTENTS : SHEET NO.
PTR NO. :
PROPOSED TWO STOREY WITH ROOF DECK FIRST FLOOR LIGHTING LAYOUT
DATE ISSUED :
PLACE ISSUED : SECOND FLOOR LIGHTING LAYOUT
COMMERCIAL BUILDING LUCILLE L. LINGATONG SINGLE LINE DIAGRAM - GF E-1
NIJAGA STREET, BRGY. POBLACION, CALBAYOG CITY WESTERN SAMAR BUILDING OWNER SCHEDULE OF LOADS - GF 10 11
Professional Electrical Engineer TIN : ELECTRICAL SPECIFICATIONS