Scribd
Upload
293 views3 pages

Power Electronics Lab Assignment-VII: Design & Simulation of Flyback Converter

This document provides instructions for simulating a flyback converter circuit in MATLAB Simulink. It includes the components required, the circuit diagram, how to set up the simulation by adding blocks from the Simulink library, and how to configure the pulse generator block. It also lists the component values used in the simulation, shows the Simulink model, and provides the equations to calculate the output voltage based on the simulation results.

Uploaded by

KASHIF zaman
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
293 views3 pages

Power Electronics Lab Assignment-VII: Design & Simulation of Flyback Converter

This document provides instructions for simulating a flyback converter circuit in MATLAB Simulink. It includes the components required, the circuit diagram, how to set up the simulation by adding blocks from the Simulink library, and how to configure the pulse generator block. It also lists the component values used in the simulation, shows the Simulink model, and provides the equations to calculate the output voltage based on the simulation results.

Uploaded by

KASHIF zaman
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Power Electronics Lab Assignment-VII

DESIGN & SIMULATION OF FLYBACK CONVERTER.

OBJECTIVE:

Simulation and Analysis of Isolated DC-DC Converter (Flyback Converter).

COMPONENTS REQUIRED:

MATLAB Simulink.

CIRCUIT DIAGRAM:

Fig: Flyback Converter Circuit.

SETTING UP SIMULATION:

1) Run MATLAB software by double click on desktop icon.


2) Open blank untitled Simulink model window for creating a new model.
3) Drag and drop required blocks from Simulink library Browser window.
4) Make the circuit as shown in circuit diagram.
Power Electronics Lab Assignment-VII
PULSE GENERATOR:
The Pulse Generator block generates square wave pulses at regular intervals. The block
waveform parameters, Amplitude, Pulse Width, Period, and Phase delay, determine the
shape of the output waveform. The following figure shows how each parameter affects the
waveform.
 In Time-Based mode, Simulink computes
the block output only at times when the
output actually changes.

 In Sample-Based mode, the block


computes its outputs at fixed intervals that
you specify.

VALUES:
Vi 24V
Vo 40V
C 17.85e-6f
R 40Ω
P 40W
fs 100kHz
Power Electronics Lab Assignment-VII
SIMULINK MODEL:

SCOPE OUTPUT:

CALCULATION:
In Flyback converter, the output voltage (VOUT) across the load resistor is denoted by:

𝑁2 𝑉0 (1 − 𝐷)
= ∗
𝑁1 𝑉𝑠 𝐷
For capacitor;
∆𝑉0 𝐷
=
𝑉0 𝑅𝐶𝐹

You might also like