Pds - Floor Hardener NM

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

FLOOR HARDENER NM

PREMIXED NON METALLIC POWDER FLOOR HARDENER

Key Features Performance Properties


Specific Gravity 3.2g/cm3
–– Provides a monolithic hardening
Compressive Strength > 60 Mpa
surface within the concrete matrix
200% better than plain
–– Provides a wear resistant surface
Abrasion Strength concrete
–– Provides high impact resistance (BS 6431 : Part 20)
–– Easy to use and economical No rusting after 100
–– Non-slip characteristics Resistance to Rusting hours of salt spray
–– Resists oil and grease penetration, and (ASTM B117-97)
reduces dusting Flammability Non-Flammable

to stiffen sufficiently to bear the weight of a finisher


Description
before proceeding to the next stage.
Bostik Floor Hardener NM is a pre-blended, ready to use
and dry shake formulation for hardening freshly placed application instruction
horizontal concrete slabs and toppings. Floor Hardener Floor Hardener NM should be applied in two coats using
NM produces a hard, dense, wear resistant surface which a dry shake method of uniformly broadcasting the
resists corrosion and absorption of grease, oils, alkalis and product onto the surface of the freshly placed concrete.
most chemicals. Typical areas of use include concrete
floors in garages, steel mills, generating plants, loading Broadcast 2/3 of the Floor Hardener NM onto the fresh
platforms and wherever is heavy-duty wear resistant concrete surface. Float the broadcasted material into
floor finish is required. the surface with a mechanical or manual float after the
hardener achieves a uniform moistened appearance. Do
Recommended uses
not use steel trowel.
• Ideal for use in warehouse, factories, car parks, driving
and loading ramps, garages, mechanical / power
When the water sheen has again disappeared, broadcast
rooms, wet rooms and outdoor surface of all kinds, etc.
the remaining 1/3 of the Floor Hardener NM onto the
• Easy to apply and even easier to maintain
surface. Float the concrete surface in the same way as
• High abrasion and impact resistance
before. After the surface has achieved proper firmness,
• Suitable for constantly wet areas; Non-skid and Non-
proceed with normal finishing procedures. Do not over
slip
trowel.
• Dust-proof
• Resistant to gas, oil, mineral, solvents and other
Final finishing of the floor using the blades of a power
chemicals
float can be carried out when the floor has stiffened
suRFACE preparation sufficiently so that damage will not caused. As soon as
Concrete for single course monolithic floors should be the surface will not be marred, apply Bond`N' Cure to the
capable of achieving a 28-day compressive strength surface immediatedly by roller or spray.
of 20 Mpa (30 Mpa for heavey duty traffic areas) with a
coverage
slump between 75mm and 100mm. Concrete should not
Light to Moderate Duty - 2.5 to 3.5kg/m2
contain calcium chloride.
Moderate to Heavy Duty - 3.5 to 5.0kg/m2
Super Heavy Duty - 5.0 to 7.5kg/m2
Place concrete and consolidate with vibrators if
necessary. Strike off concrete level. Further level and PACKAGING
consolidate using a wooden bull float. Complete this 25kg bag
operation before any bleed water appears. If there is
free-bleed water on the surface, remove it just prior to clean up
the floating. The base concrete should then be allowed Immediately after use, equipment and tools should be
cleaned with clean water.
PAGE 1 OF 2
STORAGE ANd SHELF LIFE
All material shall be stored under cover in a manner that
will prevent damage preferable on pallets and protected
from excessive heat and moisture. Do not freeze. Bostik
Floor Hardener NM has a shelf life of 12 months from
date of manufacture when kept in a dry store in the
original, unopened bags.

HEALTH AND SAFETY


This product contains cement powders which, when
mixed with water or upon becoming damp, release
alkalis that can be harmful to skin. During use, avoid
inhalation of the dust and contact with the skin or eyes.
Wear suitable protective clothing, eye protection, gloves
and respiratory equipment (particularly in confined
spaces). The use of barrier creams to provide addiitional
skin protection is also advised. In case of contact with
the skin, rinse with plenty of clean water, then cleanse
thoroughly with soap and water. In case of contact
with eyes, rinse immediately with plenty of clean water
and seek medical advice. If swallowed, seek medical
attention immediately - do not induce vomitting. For
more information, refer to Material Safety Data Sheet.

BOSTIK HOTLINE
The information and recommendations relating to the
application and end-use of the product are given in good Smart help
faith and based on tests which we believe to be reliable.
Differing materials, substrates, environments, site +606 678 9788
conditions, and product storage, handling and application
may affect results. However, no warranty in respect
of merchantability or fitness for a particular purpose,
nor any liability arising out of any legal relationship, Bostik Findley (Malaysia) Sdn. Bhd. 1994010000474 (286152-V)
whatsoever, can be inferred either from this information, Lot 112 & 113, Kawasan Perindustrian Senawang,
or from any written recommendations, or from any other 70450 Seremban, Negeri Sembilan,
advise offered. No guarantee of their accuracy can be Malaysia
made because of the great range of field conditions and Tel : +606 678 9788 Fax : +606 678 9766
variation encountered in raw materials, manufacturing
equipment and methods. Thus, the products are sold with www.bostik.com
limited warranty only, and on condition that purchasers an Arkema company
will make their own tests to determine the suitability
of the product for their particular purposes. Under no
circumstances will Bostik be liable to anyone except for
replacement of the products or refund of the purchase
price.
This document supersedes all previously published literature.

PAGE 2 OF 2 PRODUCT : FLOOR HARDENER NM • ISSUE DATE - 01 JUNE 2015 • ISSUE NO.2 • TOTAL PAGES : 2

You might also like