Installation Instruction

PL10/ML10
Version: 2.0
Before Installation
Diagram B

C
A

K
I

L H D
E

J F

M N

1
Packing List
C
B K I F G

Mounting Hardware Package Mounting Hardware Package

D for door thickness of 39-46mm for door thickness of 47-54mm
N
A H 64mm
H
72mm

E E
L 35mm L 40mm

M M
J 30mm
J 35mm

2
Door Preparation
1. Check the door thickness and prepare the corresponding mounting
hardware package.
Door Thickness H Spindle Length J Screw Length M Screw Length L Screw Length
(mm) (mm) (mm) (mm) (mm)

30~38 56 20 10 25
39~46 64 30 10 35
47~54 72 35 10 40
55~60 80 45 10 50

Note: The standard lock includes 2 mounting hardware packages only, which are used for the door
thickness of 39-46mm and 47-54 mm separately.

2. Check door opening direction.

F F
D D

Left inward Right inward

F F

D
D
Left outward Right outward
Note: Please refer to the above picture to adjust the direction of strike plate F and latch D.

3
3. Check the required backset (60mm or 70mm).

60mm 70mm

2- 3/ 8 2- 3/ 4

70m m
60m m

2-3/4 2-3/8

70mm 60mm

Note1: Installation template has the backset Note2: The latch has two backset options: 60mm and
options of both 60mm and 70mm. 70mm, please choose either one as required.

4
Remarks
1. New lock is configured to grant any fingerprint access.
2. The lock is equipped with mechanical keys for manual unlocking. Remove mechanical keys from the
package and keep them in a safe place.
3. To power up the lock, four alkaline AA batteries (not included) are required. Non-alkaline and
rechargeable batteries are NOT recommended.
4. The operation of lock setting has a stand-by time limit of 10 seconds; if there is no any activity, the lock
will shut off after 10 seconds.
5. Keep your fingers clean when using this lock.

How To Use Mechanical Key And Change Handle Direction?

Hexagon Screw

A
N

5
Installation
1. Drill holes on the door. 2. Install the latch (D).

center line of the

handle

E
desired handle
height
D
Note1: Align the template along the vertical center
line of the latch(D) at the desired handle height,
and tape it to the door.
Note2: Mark the holes first, and then start drilling.

6
3. Install outdoor unit (B) with gasket (C) and spindle(H) on the door.

C B

Correct Position: The small triangle

must be vertically upward.

H
This position is wrong.

7
4. Install mounting plate (I) with gasket (C) on the door.

J C C B
I I

5. Install indoor unit (K).

M L

Note: Push cable into the hole first.

8
6. Insert batteries. 7. Mark and drill holes for the strike.

2mm
(5/64")

12mm

(1-9/64")
29mm
(15/32")

(2-9/32")
58mm
21mm
(53/64") F G
E
14mm
(35/64") 35mm
K (1-3/8")

8. Test the lock by rotating the back handle and using the mechanical
key (A).
Note: When the door is locked and the clutch is idle, the front handle
can be turned, but the door will remain locked.