Section 1 - Chemical Product and Company Identification
1.1 Product Name : ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT
Synonyms : EDTA, Disodium dihydrate; Disodium ethylenediamine tetraacetatedihydrate; N,N,N',N'-Ethylenediaminetetraacetic Acid, Disodium Salt, Dihydrate;EDTA (Dihydrate); (Ethylenedinitrilo) tetraaceticAcid Disodium Salt Dihydrate; Edetate Disodium, dehydrate; Disodium dihydrogenethylenediamine tetraacetate CAS No. : 6381-92-6 HS Code : 2922 49 85 Molecular Weight : 372.24 g/mol Chemical Formula : C10H14N2Na2O8.2H2O Product Code : A-2020 Brand : SMART-LAB 1.2 Manufacturer :PT.Smart-Lab Indonesia Address : Ruko Boulevard Taman Tekno Blok E No.10-11,BSD Sektor XI Serpong, Tangerang - Indonesia Website :www.smartlab.co.id Email :[email protected] For information :Telp: +62-21- 7588 0205(Hunting) , fax:+62-21-7588 0198 1.3 Application : General Chemical reagent Emergency Telephone: +62-21-7588 0205(Hunting)
Section 2 - Hazards Identification
2.1 Classification of the substance or mixture
Classification according to Regulation (EC) No 1272/2008 Eye irritation (Category 2), H319 Long-term (chronic) aquatic hazard (Category 3), H412
For the full text of the H-Statements mentioned in this Section, see Section 16.
2.2 Label elements
Labelling according Regulation (EC) No 1272/2008
Pictogram
Signal word Warning
Hazard statement(s) H319 Causes serious eye irritation. H412 Harmful to aquatic life with long lasting effects.
Precautionary statement(s) P273 Avoid release to the environment. P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Supplemental Hazard Statements none
2.3 Other hazards
This substance/mixture contains no components considered to be either persistent, bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher.
PT.SMART-LAB INDONESIA MSDS – ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT Page 1
No: F/QCL/008 Rev.01
MATERIAL SAFETY DATA SHEET
ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT
Revision : 01 Date : 24.01.2019 MSDS Number : 071
Section 3 - Composition, Information on Ingredients
General advice Consult a physician. Show this safety data sheet to the doctor in attendance.
If inhaled If breathed in, move person into fresh air. If not breathing, give artificial respiration. Consult a physician.
In case of skin contact
Wash off with soap and plenty of water. Take victim immediately to hospital. Consult a physician.
In case of eye contact
Rinse thoroughly with plenty of water for at least 15 minutes and consult a physician.
If swallowed Never give anything by mouth to an unconscious person. Rinse mouth with water. Consult a physician.
4.2 Most important symptoms and effects, both acute and delayed The most important known symptoms and effects are described in the labelling (see section 2.2) and/or in section 11
4.3 Indication of any immediate medical attention and special treatment needed No data available
Section 5 - Firefighting Measures
5.1 Extinguishing media
Suitable extinguishing media Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
PT.SMART-LAB INDONESIA MSDS – ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT Page 2
No: F/QCL/008 Rev.01
MATERIAL SAFETY DATA SHEET
ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT
Revision : 01 Date : 24.01.2019 MSDS Number : 071
5.2 Special hazards arising from the substance or mixture
Wear self-contained breathing apparatus for firefighting if necessary.
5.4 Further information
No data available
Section 6 - Accidental Release Measures
6.1 Personal precautions, protective equipment and emergency procedures
Use personal protective equipment. Avoid dust formation. Avoid breathing vapours, mist or gas. Ensure adequate ventilation. Avoid breathing dust. For personal protection see section 8.
6.2 Environmental precautions
Do not let product enter drains.
6.3 Methods and materials for containment and cleaning up
Pick up and arrange disposal without creating dust. Sweep up and shovel. Keep in suitable, closed containers for disposal.
6.4 Reference to other sections
For disposal see section 13.
Section 7 - Handling and Storage
7.1 Precautions for safe handling
Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Provide appropriate exhaust ventilation at places where dust is formed. For precautions see section 2.2.
7.2 Conditions for safe storage, including any incompatibilities
Store in cool place. Keep container tightly closed in a dry and well-ventilated place. Storage class (TRGS 510): Non Combustible Solids
7.3 Specific end use(s)
Apart from the uses mentioned in section 1.2 no other specific uses are stipulated
Section 8 - Exposure Controls, Personal Protection
8.1 Control parameters
8.2 Exposure control Appropriat engineering controls General industrial hygiene practice. Personal protective equipment Eye/face protection Safety glasses with side-shields conforming to EN166 Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU).
Skin protection Handle with gloves. Gloves must be inspected prior to use. Use proper glove removal technique (without touching glove's outer surface) to avoid skin contact with this product. PT.SMART-LAB INDONESIA MSDS – ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT Page 3 No: F/QCL/008 Rev.01
MATERIAL SAFETY DATA SHEET
ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT
Revision : 01 Date : 24.01.2019 MSDS Number : 071
Dispose of contaminated gloves after use in accordance with applicable laws and good laboratory practices. Wash and dry hands.
The selected protective gloves have to satisfy the specifications of EU Directive 89/686/EEC and the standard EN 374 derived from it.
Full contact Material: Nitrile rubber Minimum layer thickness: 0.11 mm Break through time: 480 min Material tested:Dermatril® (KCL 740, Size M)
Splash contact Material: Nitrile rubber Minimum layer thickness: 0.11 mm Break through time: 480 min Material tested:Dermatril® (KCL 740, Size M)
Body Protection Complete suit protecting against chemicals, The type of protective equipment must be selected according to the concentration and amount of the dangerous substance at the specific workplace.
Respiratory protection For nuisance exposures use type P95 (US) or type P1 (EU EN 143) particle r (US) or type ABEKP2 (EU EN 143) respirator cartridges. Use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU)..
Control of environmental exposure
Do not let product enter drains.
Section 9 - Physical and Chemical Properties
9.1 Information on basic physical and chemical properties
Appearance Form: crystals Colour: white Odour odourless Odour Threshold No data available pH No data available Melting point/freezingpoint Melting point/range: 248 °C Initial boiling point and boiling range No data available Flash point No data available Evaporation rate No data available Flammability (solid, gas) The product is not flammable. Upper/lower flammability or No data available explosive limits No data available Vapour pressure No data available Vapour density No data available Relative density No data available Water solubility No data available Partition coefficient: noctanol/water No data available Auto-ignition temperature No data available Decomposition temperature 255 °C - Viscosity No data available
PT.SMART-LAB INDONESIA MSDS – ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT Page 4
No: F/QCL/008 Rev.01
MATERIAL SAFETY DATA SHEET
ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT
Revision : 01 Date : 24.01.2019 MSDS Number : 071
Explosive properties No data available
Oxidizing properties No data available
9.2 Other safety information
Bulk density ca.700 kg/m3
Section 10 - Stability and Reactivity
10.1 Reactivity No data available
10.2 Chemical stability
Stable under recommended storage conditions.
10.3 Possibility of hazardous reactions
No data available
10.4 Conditions to avoid
No data available
10.5 Incompatible materials
Strong oxidizing agents
10.6 Hazardous decomposition products
Hazardous decomposition products formed under fire conditions. - Carbon oxides, Nitrogen oxides (NOx), Sodium oxides Other decomposition products - No data available In the event of fire: see section 5
Section 11 - Toxicological Information
11.1 Information on toxicological effects
Acute toxicity LD50 Oral - Rat - 4.500 mg/kg (OECD Test Guideline 401)
Skin corrosion/irritation No data available(Edetate disodium dihydrate)
Carcinogenicity IARC: No component of this product present at levels greater than or equal to 0.1% is identified as probable, possible or confirmed human carcinogen by IARC.
PT.SMART-LAB INDONESIA MSDS – ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT Page 5
No: F/QCL/008 Rev.01
MATERIAL SAFETY DATA SHEET
ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT
Revision : 01 Date : 24.01.2019 MSDS Number : 071
Reproductive toxicity No data available(Edetate disodium dihydrate)
Specific target organ toxicity - single exposure
No data available(Edetate disodium dihydrate)
Specific target organ toxicity - repeated exposure
No data available
Aspiration hazard No data available(Edetate disodium dihydrate)
Additional Information RTECS: AH4410000 To the best of our knowledge, the chemical, physical, and toxicological properties have not been thoroughly investigated.
Section 12 - Ecological Information
12.1 Toxicity Toxicity to fish LC50 - Lepomis macrochirus - 41 mg/l - 96 h
12.2 Persistence and degradability
No data available
12.3 Bioaccumulative potential
No data available
12.4 Mobility in soil
No data available
12.5 Results of PBT and vPvB assessment
This substance/mixture contains no components considered to be either persistent, bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher.
12.6 Other adverse effects
Harmful to aquatic life with long lasting effects.
Section 13 - Disposal Considerations
13.1 Waste treatment methods
Product Dissolve or mix the material with a combustible solvent and burn in a chemical incinerator equipped with an afterburner and scrubber. Offer surplus and non-recyclable solutions to a licensed disposal company. Waste material must be disposed of in accordance with the Directive on waste 2008/98/EC as well as other national and local regulations. Leave chemicals in original containers. No mixing with other waste. Handle uncleaned containers like the product itself.
Contaminated packaging Dispose of as unused product.
PT.SMART-LAB INDONESIA MSDS – ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT Page 6
No: F/QCL/008 Rev.01
MATERIAL SAFETY DATA SHEET
ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT
Revision : 01 Date : 24.01.2019 MSDS Number : 071
Section 14 - Transport Information
14.1 UN number ADR/RID: - IMDG: - IATA: - 14.2 UN proper shipping name ADR/RID: Not dangerous goods IMDG: Not dangerous goods IATA: Not dangerous goods 14.3 Transport hazard class(es) ADR/RID: - IMDG: - IATA: - 14.4 Packaging group ADR/RID: - IMDG: - IATA: - 14.5 Environmental hazards ADR/RID: no IMDG Marine pollutant: no IATA: no 14.6 Special precautions for user Further information No data available
Section 15 - Regulatory Information
15.1 Safety, health and environmental regulations/legislation specific for the substance or mixture This safety datasheet complies with the requirements of Regulation (EC) No. 1907/2006. 15.2 Chemical safety assessment For this product a chemical safety assessment was not carried out
Section 16 - Additional Information
Full text of H-Statements referred to under sections 2 and 3.
H319 Causes serious eye irritation. H412 Harmful to aquatic life with long lasting effects.
National Fire Protection Association (U.S.A.):
Health: 1 Flammability: 0 Reactivity: 0
Further information The above information is believed to be correct but does not purport to be all inclusive and shall be used only as a guide. The information in this document is based on the present state of our knowledge and is applicable to the product with regard to appropriate safety precautions. It does not represent any guarantee of the properties of the product. PT. Smartlab Indonesia Corporation and its Affiliates shall not be held liable for any damage resulting from handling or from contact with the above product. See www.sigmaaldrich.com and/or the reverse side of invoice or packing slip for additional terms and conditions of sale.
PT.SMART-LAB INDONESIA MSDS – ETHYLENEDIAMINETETRAACETIC ACID DISODIUM SALT Page 7
