Traffic control -- Britannica Online Encyclopedia 16/04/21 23.

20

Traffic control
Road traffic control

At the broadest level, road traffic control includes the layout of streets to serve a
variety of travel needs in a region. Highways or expressways carry through
traffic at high speed; arterial streets carry traffic within and across urban areas;
and local streets provide low-speed travel but access to many local destinations.
The hierarchy of streets that perform at different levels of speed and provide
different levels of access form the foundation upon which traffic control
problems evolve. Long delays and frequent accidents are common outcomes of
inadequate road planning, which results in an insufficient number of roads to
meet travel needs. While traffic control may help, it is not a substitute for
adequate provision of transportation supply.

History

Traffic congestion, often bad enough to require drastic control measures, was a
feature of city life at least as early as Roman times. A basic cause, then as now,
was poor city planning, with roads laid out in such a way as to bring traffic from
all quarters to a central crossing point. In the 1st century BC Julius Caesar
banned wheeled traffic from Rome during the daytime, a measure gradually
extended to cities in the provinces. Late in the 1st century AD the emperor
Hadrian was forced to limit the total number of carts entering Rome.

About 1500 Leonardo da Vinci, envisioning a revolutionary solution to urban

traffic problems—then acute in the crowded and busy Italian cities—proposed
separating wheeled and pedestrian traffic by creating routes at different levels.

https://www.britannica.com/print/article/601854 Page 1 of 8
Traffic control -- Britannica Online Encyclopedia 16/04/21 23.20

Except for the railway, however, few segregated route systems were established
before the 20th century.

Congestion was severe enough in European cities of the 17th century to require
ordinances prohibiting parking on certain streets and establishing one-way
traffic. The advent of the railroad brought temporary relief to the growing
problem of road traffic control, though it created congestion at terminals inside
cities. The automobile, with its increase first in speed and then in numbers over
horse-drawn transport, rapidly created a new situation that was to become one
of the characteristic problems of urban industrialized society in the 20th
century.

Traffic elements

Road traffic control at its most elemental level is achieved through the use of a
system of signs, signals, and markings. Elaborate engineering standards are
used to assure that the traffic control devices convey a clear and simple meaning
to the motorist. A comparable and matching education program is needed,
through driver-licensing authorities, to assure that those who operate motor
vehicles understand the rules of the road and the actions that they are required
or advised to take when a particular control device is present.

Each traffic control device is governed by standards of design and usage; for
example, stop signs always have a red background and are octagonal in shape.
Design standards allow the motorist to quickly and consistently perceive the
sign in the visual field along the road. Standard use of colours and shape aids in
this identification and in deciding on the appropriate course of action.

https://www.britannica.com/print/article/601854 Page 2 of 8
Traffic control -- Britannica Online Encyclopedia 16/04/21 23.20

Standards also exist on the use of the control device, such as guidelines as to
when circumstances warrant the use of two-way stop signs or traffic signals.
Standards also are used to locate control devices in a particular circumstance.
For example, signs on high-speed expressways or motorways need to be placed
well in advance of exits to allow sufficient time for drivers to choose a course of
action. Standards for location allow drivers to expect and anticipate these
devices at certain distances from decision points. Adhering to these standards
promotes safety; failure to adhere increases the risk of driver error and,
ultimately, accidents.

The design and use of traffic control devices must also recognize the
tremendous mix of vehicles that use highway systems. The devices must be
useful for pedestrians and bicyclists as well as drivers of 80,000- to 120,000-
pound trucks that are up to 100 feet long. It is not the size and weight
differences per se that are important but what they imply for vehicle
performance. On a road that is heavily used by trucks, for example, the location
of warning signs for a dangerous intersection must be placed sufficiently in
advance to compensate for a truck’s longer stopping distance (as compared to
that of a car). Design of devices such as guardrails must take into account the
larger mass and higher centre of gravity of trucks as well. Because trucks serve
so many purposes, highly specialized vehicles have evolved to meet different
needs. While principles of standardization would indicate a desire to limit the
type and configuration of trucks in use, characteristics of transportation markets
often lead to specialized vehicle developments. The conflict between
standardization and market need, and the sheer size and bulk of many trucks,

https://www.britannica.com/print/article/601854 Page 3 of 8
Traffic control -- Britannica Online Encyclopedia 16/04/21 23.20

has led to a series of controversies concerning their safety performance. As long

as private, personally owned automobiles must share roadway space with very
large commercially owned trucks, the conflicts and controversy are likely to
continue.

Common control techniques

Traffic signal controllers are electronic devices located at intersections that

control the sequence of the lights. Along with computers, communications
equipment, and detectors to count and measure traffic, the controllers are
frequently grouped together to control large numbers of traffic signals, either at
intersections in a city or on ramps approaching expressways and motorways.
While the detailed brand and type of equipment vary greatly, the functions
performed by the systems are generally consistent.

There are four basic elements in a computerized traffic control system:

computer(s), communications devices, traffic signals and associated equipment,
and detectors for sensing vehicles. Traffic flow information is picked up by the
detectors from the roadway and transmitted to the computer system for
processing. The detectors are normally embedded in or suspended above the
roadway. Vehicle counts and speeds are typically measured; vehicle type (e.g.,
auto or truck) also may be obtained. The computer processes the traffic flow
data to determine the proper sequence for the lights at the intersections or
ramps. The sequencing information is transmitted from the computer through
communications equipment to the signals. In order to assure safe and proper
operation, information is also transmitted from the traffic signals to the
computer, confirming proper operation. Humans can interact with the system by

https://www.britannica.com/print/article/601854 Page 4 of 8
Traffic control -- Britannica Online Encyclopedia 16/04/21 23.20

accessing the computer system in some way.

While these are the general principles, important variations are possible. First, it
is common to find some form of computer as part of the traffic signal at the
intersection or ramp to be controlled. This allows the local computer to process
traffic flow data directly, reducing communications needs and costs. Another
variation is that selected vehicles themselves may transmit traffic data directly
to the computer system. This is frequently combined with the ability to receive
information in the vehicle regarding points of congestion, so the driver can
choose to avoid them. If the two-way communication exists between the
vehicles and computer system, it may not be necessary to have separate
physical detectors.

Another area of application for traffic control devices is their use in traffic
restraint (often called traffic “calming”). Rather than use traffic control to
increase efficiency of movement, controls are used to create impediments that
restrain traffic from sensitive areas. Most commonly applied in older cities
whose road network does not match current needs, traffic restraint seeks to
funnel traffic onto particular routes by creating impediments to movement on
others. These other routes typically have some special value—a historic site or a
residential character—that requires protection. Devices typically used include
speed bumps, barricades to block streets, turn prohibitions, stop signs, and
raised pavement markers.

Traffic restraint also includes programs to foster bicycle and pedestrian travel.
Wider sidewalks, sometimes including tables and benches, and bicycle lanes

https://www.britannica.com/print/article/601854 Page 5 of 8
Traffic control -- Britannica Online Encyclopedia 16/04/21 23.20

frequently accompany restraint actions. These programs recognize that what is

good for vehicular travel may not necessarily be positive for other road users,
the environment, or the neighbourhood. An unfortunate aspect of these
programs is that their benefits and costs are highly localized. Those living on
the “right” side of the restraint device generally experience slow speed and
lower traffic volume. Those living along the routes onto which the traffic is
funneled must endure increased vehicle volumes and speeds.

Traffic control also can be used to give priority to high-occupancy passenger

modes. The objective of such actions is to emphasize people rather than vehicle
movement. A variety of techniques are available and are employed in priority
treatment approaches. The most common is the dedication of special lanes to
the use of priority, or high-occupancy, vehicles. Buses and car pools can use the
lanes to move at high speeds along congested expressways and motorways,
bypass queues at expressway ramps, and move along congested arterial streets.
Because these special lanes are designed to operate uncongested, they provide
an incentive, through reduced travel times, for travelers to leave private single-
passenger automobiles and travel by multipassenger modes. Buses also may be
given priority by allowing only them to turn at intersections and to be provided
with extra green time at a traffic signal. The undesirable feature of such systems
is that they provide improved service to high-occupancy modes while
sustaining or increasing congestion for others. The residual congestion for other
road users may result in continued wasteful fuel consumption and high vehicle
pollutant emission.

New concepts

https://www.britannica.com/print/article/601854 Page 6 of 8
Traffic control -- Britannica Online Encyclopedia 16/04/21 23.20

Rapid and continuous advances in communications and computer technology

are spurring a host of new concepts in road traffic control. Automobiles
equipped with on-board computers, driver displays, and communications
devices will receive instructions about the optimal path to a destination from a
traffic control centre. The vehicle also will periodically report its travel time and
speed to be used as part of the information for the computer to give advice. In
more advanced systems, the timing of traffic signals at intersections and ramps
will be coordinated with the routing advice. Rather than simply accommodating
vehicles that travel through the network, the system will cause patterns of travel
to be altered. Computers and sensors within the vehicle will monitor the
operation of critical safety systems (e.g., brakes, steering), warning the driver
when conditions exceed nominal values.

Communications and computers also will aid the movement of trucks and other
commercial vehicles in urban areas. A dispatcher will be able to alter the
schedule while the driver is on the road. For these companies, this means
reduced costs, and for their customers, improved service. Drivers on long-
distance intercity trips can be warned of impending bad weather. They also can
receive warnings if they are entering a curve too quickly or an intersection too
fast. Road safety should be greatly enhanced by such systems.

Public transit users should be able to receive more accurate information

concerning travel time and seat availability on buses and trains. If accurate
information can be provided in the home or office, the systems can spread peak
loads, making service less expensive to provide and the trip more comfortable
for the traveler. Those who are informed of congestion or uncomfortable

https://www.britannica.com/print/article/601854 Page 7 of 8
Traffic control -- Britannica Online Encyclopedia 16/04/21 23.20

conditions can use another system to find a match for a car pool participant.
Alternatively, individuals may “telecommute,” staying at home and working
with their office electronically.

Lastly, the ultimate system is viewed as an automatic vehicle-control system in

which a driver’s vehicle is checked at an authorized station, then proceeds on a
highway, lane, or local street. The spacing to the vehicle ahead and lateral
control within the lane are determined by on-board computers. Maximum flows
are expected to increase from 2,000 vehicles per hour per lane to as many as
10,000 to 20,000. The increased flows will mean substantial reductions in
congestion and, because vehicles are automatically controlled, improvements in
road safety through the elimination of accidents due to driver error.

Citation Information
Article Title: Traffic control
Website Name: Encyclopaedia Britannica
Publisher: Encyclopaedia Britannica, Inc.
Date Published: 20 August 2018
URL: https://www.britannica.com/technology/traffic-control
Access Date: April 16, 2021

https://www.britannica.com/print/article/601854 Page 8 of 8