Scribd
Upload
670 views1 page

USR DR302 Quick Start Guide

The document provides a quick start guide for configuring a USR-DR302 serial to Ethernet converter. It describes connecting the device to an Ethernet network using an Ethernet cable and connecting a serial device to the RS-485 port. It also lists the default IP address and login credentials for accessing the web configuration page to assign network settings like the IP address, subnet mask, and gateway. The guide recommends downloading and installing setup software to configure the device from a PC.

Uploaded by

jof853
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
670 views1 page

USR DR302 Quick Start Guide

The document provides a quick start guide for configuring a USR-DR302 serial to Ethernet converter. It describes connecting the device to an Ethernet network using an Ethernet cable and connecting a serial device to the RS-485 port. It also lists the default IP address and login credentials for accessing the web configuration page to assign network settings like the IP address, subnet mask, and gateway. The guide recommends downloading and installing setup software to configure the device from a PC.

Uploaded by

jof853
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

2.Serial Port 4.

Configure USR-DR302 via Web page

RS-485 Terminal Port (A,B,G) ■ Assign a static IP address to your computer in the
Quick Start Guide 192.168.0.2 to 192.168.0.254 range.
Tiny Size RS485 to Ethernet Serial Converter
Mask 255.255.255.0. This is necessary to ensure that
MODEL USR-DR302
your computer can communicate with DR302 converter

■ The default IP address is 192.168.0.7 Open your web

Pin Definition Des browser and enter this IP to connect with DR302 for
configure
Power supply: 5-36V DC
Power
1
Interface
Wiring needs to check Default Parameters
marks ‘+’ “-”
User Name admin

RS232 Based on the photo,from Password admin


1. Hardware Installation 2
Terminal right to left is A,B,G IP address 192.168.0.7

 Use a standard Ethernet cable to connect the DR302 Mask 255.255.255.0


3 RJ45 Port Ethernet Port Gateway 192.168.0.1
to an Ethernet router or connect it directly to a PC.
Work Mode TCP Client
 RS-485 can connect with a PC or other serial port Local Port 0

device by serial cables


3. Software Installation Baud Rate 115200
 SetupSoftware:https://www.usriot.com/support/downlo Target Port 8234
ads/usr-m0-setup-software-v224288.html
Target IP 192.168.0.201

Notes: Be sure you have administrative rights and


Parity bit/Data bit/Stop bit None/8/1
disable any firewalls/anti-virus software when install

software.

You might also like