APS48Z Owners Guide Rev. 0 - 11.13.19

Owner’s Guide
APS48Z
Security / Keyless Entry

System
IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is
applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR
SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information.
2019 Voxx Electronics Corporation. All rights reserved. 1

Table of Contents
Using Your Remote Control..................................................................... 3
Arming the Security System............................................................... 3
Disarming the Security System.......................................................... 3
Silent Arming & Disarming.................................................................. 3
Using the Personal Protection Alarm.................................................. 3
Car Finder.......................................................................................... 3
Activating Trunk Release (optional).................................................... 3
Activating AUX Output (optional)........................................................ 3
Bypassing the Shock Sensor............................................................. 4
Valet Mode......................................................................................... 4
Manually Overriding the Security System.......................................... 4
Anti-Hijack Operation......................................................................... 5
Status LED, Light Flashes and Siren/Horn Indications........................ 6
Replacing Remote Control Batteries...................................................... 6
Warranty Information............................................................................... 7
2 APS48Z Owners rev0

Using Your Remote Control
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the button. The
parking lights will flash one (1) time, indicating the system is armed, has locked the
doors (if equipped and connected) and activated the starter disable feature. The LED
status indicator will blink steadily, once per second.
Disarming the Security System

To disarm the system press the button. The parking lights will flash three (3) times,
and remain ON for four (4) seconds indicating the system is disarmed and has
unlocked the doors (if equipped and connected).
Note: If the system was triggered while the driver was away from the vehicle it will
beep and flash the parking lights four (4) times.
Silent Arming or Disarming the Security System

To Arm or Disarm the system silently, press then or buttons. The parking lights
will flash indicating the system has armed / disarmed.
Note: If the system was triggered it will not beep to notify the driver of the alarm
trigger. The system will flash the parking lights only.
Using the Personal Protection Alarm (Panic)

Press and hold the button for 2 seconds to activate the personal protection alarm.
During panic mode, the normal function of the transmitter buttons will be suspended.
To stop the alarm, press the or button on the transmitter.
Using the Car Finder Feature

When the system is Armed, Press the button to locate your vehicle. The system will
flash the parking lights and beep ten (10) times. To stop the Car Finder feature, Press
the one (1) time.
Activating the Trunk Release Feature (Optional)

If this feature is enabled on your system, pressing and holding the button for 3
seconds will open the vehicle’s trunk or hatch.
Activating the AUX Output (Optional)

If this feature is enabled on your system, pressing the and buttons simultaneously
will activate an optional feature. This feature can be programmed for a wide range
of functions like power window or sunroof automation, please consult your installing
dealer to determine the functionality of your system.

Bypassing The Shock Sensor
The on-board security shock sensor has two stages of detection, Warn-Away and
Full Trigger. To arm the system and shock sensor press the button. The system will
beep and the lights will flash one (1) time.
To Arm the system and bypass the shock sensor press the button then press the
button within two (2) seconds.
To Arm the system and bypass both the shock sensor and door trigger detection press
the button then press the button within two (2) seconds.
Valet Mode
To enter or exit valet mode press the then press the button within two (2)
seconds. When valet mode is activated the status LED will light solid, and all security
functions will be disabled.
Manually Overriding the Security System
Your system can be disarmed without the use of the remote control. This is
necessary to operate your vehicle if the transmitter is lost or its battery fails. To by-
pass the alarm system;
1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the ON position.
3. Within five (5) seconds, press and hold the valet push button switch for
one (1) second.
The alarm system will stop sounding and enter the (by-passed) mode. You can now
start and operate the vehicle normally.

Anti-Hijack Operation
This system has two (2) options for Anti-Hijack operation, Mode 1 (default) or Mode 2.
Contact your installation center for more information.
Mode 1
This option has two (2) methods to activate the Anti-Hijack feature.
1. Ignition ON: The system will activate the Anti-Hijack feature when the vehicle’s
ignition is turned ON. Pressing the button within ten (10) seconds of Ignition
ON will bypass Anti-Hijack.
2. Door Open: If the vehicle’s door is opened while the ignition is ON, the system
will activate the Anti-Hijack feature. Pressing the button within ten (10) seconds
of door open will bypass Anti-Hijack.
Mode 2
This option has one (1) method to activate the Anti-Hijack feature.
1. Door Open: If the vehicle’s door is opened while the ignition is ON, the system
will activate the Anti-Hijack feature. Pressing the button within ten (10) seconds
of door open will bypass Anti-Hijack.
If the Anti-Hijack feature is not bypassed within the first ten (10) seconds, the module
will begin to notify the user that the Anti-Hijack feature is activated.
• 0 - 10 seconds: No Notification.
• 11 - 40 seconds: The LED will flash rapidly.
• 41 - 60 seconds: The LED will flash rapidly and the system will beep one (1)
time every two (2) seconds.
• > 61 seconds: The system will sound and the parking lights will flash
continuously and the Starter Kill will be activated.
Note: After the first ten (10) seconds the Manual Override procedure is required to
bypass the Anti-Hijack feature.

Status LED, Light Flashes, and Siren/Horn Indications
Status LED Flash Indications
LED Flashes Function
OFF Disarmed
Slow Flash Armed
Fast Flash Passive Arming Countdown
ON (Solid) Valet Mode
Siren/Horn Chirp Indications
Chirps Function
1 Arm
3 Disarm
4 Disarm / Triggered
Parking Light Flash Indications
Flashes Function
1 Arm
3 Disarm
4 Disarm / Triggered
Replacing Remote Control Batteries

4 Button Remote Control - Model 91Z
The CR2032 battery inside each remote control should last approximately 1 year under
normal use. When the batteries become weak you will notice the remote control range
(the distance from the vehicle the remote control will work) deteriorate and the small LED
on the remote control will dim. To replace the remote control batteries:
1. Using a coin, disassemble the halves of the remote control.
2. Remove the old battery, observing the +/- symbols on the batteries and
replace with a new battery.
3. Reassemble the halves of the remote control.
4. Test operation of the remote control.

LIMITED LIFETIME WARRANTY
Applies to Prestige Series Control Modules, Sirens, Sensors, and Relays.
Voxx Electronics Corporation (the Company) warrants to the original purchaser of this
product that should this product or any part thereof, (other than transmitters) under nor-
mal use and conditions, be proven defective in material or workmanship during the life-
time of the vehicle, in which it was originally installed from the date of original purchase
such defect(s) will be repaired or replaced with new or reconditioned product, (at the
Company’s option) without charge for parts or repair labor. A transmitter is warranted for
12 months from the date of original purchase.
To obtain repair or replacement within the terms of this Warranty, the product is to
be delivered with proof of warranty coverage (e.g. dated bill of sale), specification of
defect(s), transportation prepaid, to an approved warranty station. This Warranty is not
transferable.
This Warranty does not cover damage to the vehicle’s electrical system or costs
incurred for removal or reinstallation of the product. This Warranty does not cover bat-
teries, broken LCD or OLED display screens, nor apply to any product or part thereof
which, in the opinion of the Company, has suffered or been damaged through alteration,
improper installation, mishandling, misuse, abuse, neglect, accident, or by removal or
defacement of the factory serial number/bar code label(s).
This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED WAR-
RANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, SHALL
BE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. IN NO CASE
SHALL THE COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL
DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY. No person or rep-
resentative is authorized to assume for the Company any liability other than expressed
herein in connection with the sale of this product.
The company does not warrant that this product cannot be compromised or circum-
vented. THE EXTENT OF THE COMPANY’S LIABILITY UNDER THIS WARRANTY
IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO
EVENT, SHALL THE COMPANY’S LIABILITY EXCEED THE PURCHASE PRICE PAID
BY PURCHASER FOR THE PRODUCT WITHOUT COST OF INSTALLATION.
Some states do not allow limitations on how long an implied warranty lasts or the
exclusion or limitation of incidental or consequential damage so the above limitations or
exclusions may not apply to you. This Warranty gives you specific legal rights and you
may also have other rights which vary from state to state.
Voxx Electronics Corporation, 180 Marcus Blvd., Hauppauge, New York 11788 / 1-800-645-4994
Voxx Electronics Corporation.
Customer Service 1-800-225-6074
WWW.VOXXELECTRONICS.COM
FCC COMPLIANCE
This device complies with Part 15 of the FCC rules and with RSS-210 of
Industry Canada. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including any interference that
may cause undesired operation.
Warning!
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
PATENTED: www.voxxintl.com/company/patents

APS48Z Owners Guide Rev. 0 - 11.13.19

Uploaded by

Copyright:

Available Formats

APS48Z Owners Guide Rev. 0 - 11.13.19

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

APS48Z Owners Guide Rev. 0 - 11.13.19

Uploaded by

Copyright:

Available Formats

Owner’s Guide

Security / Keyless Entry

2019 Voxx Electronics Corporation. All rights reserved. 1

Status LED, Light Flashes and Siren/Horn Indications........................ 6

Replacing Remote Control Batteries...................................................... 6

2 APS48Z Owners rev0

Disarming the Security System

Silent Arming or Disarming the Security System

Using the Personal Protection Alarm (Panic)

Using the Car Finder Feature

Activating the Trunk Release Feature (Optional)

Activating the AUX Output (Optional)

2019 Voxx Electronics Corporation. All rights reserved. 3

Manually Overriding the Security System

4 APS48Z Owners rev0

2019 Voxx Electronics Corporation. All rights reserved. 5

Replacing Remote Control Batteries

6 APS48Z Owners rev0

8 APS48Z Owners rev0

You might also like