BA5937FP CD ROM Motor Drivers
BA5937FP CD ROM Motor Drivers
The BA5937AFP is a 4-channel BTL driver developed for use with CD players. In addition to internal drivers for the focus
coil, tracking coil, and sled motor, it also contains a driver for the loading motor.
FApplications
CD-ROM, CD players
FFeatures
1) Perfect for compact applications with the use of the 4) External mute pin enables the muting of the output
HSOP 28-pin power package. current for channels 1 and 4.
2) Internal thermal shutdown circuit. 5) Power supply is divided into three systems
3) Gain is adjustable with externally connected resistor. (VCC1 = ch1 and ch4, VCC2 = ch2 and current source,
(For channels 1, 3, and 4.) VCC3 = ch3).
632
Optical disc ICs BA5937AFP
Block diagram
Pin descriptions
633
Optical disc ICs BA5937AFP
634
Optical disc ICs BA5937AFP
FElectrical characteristics (unless otherwise noted, Ta = 25_C, VCC = 8V, RL = 8Ω, VBIAS = 2.5V)
635
Optical disc ICs BA5937AFP
Measurement circuit
636
Optical disc ICs BA5937AFP
Application example
637
Optical disc ICs BA5937AFP
Operation notes
(1) Output mode switch for loading motor driver (VCC = 8V)
638
Optical disc ICs BA5937AFP
(2) Voltage setting for loading motor driver (ex: forward mode)
(3) The BA5937AFP contains a thermal shutdown cir- (6) If the voltage of the thermal shutdown, mute ON, or
cuit. bias pin drops, the mute is activated; however, in these
When the chip temperature reaches 175C (Typ.), the situations, only the drivers are muted. Also, the output pin
output current is muted. If the chip temperature then voltage becomes the internal bias voltage (approx.
drops below 150C (Typ.), then the mute is released. (VCC*VF) / 2).
(4) If the voltage of the bias pin (pin 23) drops below (7) Connect a bypass capacitor (approx. 0.1µF) be-
1.0V (Typ.), outputs are muted. tween the bases of the power supply pins of this IC.
For normal conditions, have the voltage above 1.4V and (8) Even though the radiation fins are connected to
below 6.5V. ground within the package, be sure to also connect them
(5) By having the mute pin (pin 7) voltage pulled up to to a ground externally as well.
2.0V or greater, you can mute the output current for chan-
nels 1 and 4. For normal conditions, have pin 7 open or
at 0.5V or below.
639
Optical disc ICs BA5937AFP
640