Scribd
Upload
60 views1 page

Cable Making Instructions

Uploaded by

Teguh Priyono
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
60 views1 page

Cable Making Instructions

Uploaded by

Teguh Priyono
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Cable making instructions

This document explains how the special OBD cable for the ECUSim Lit software can be made.

1. Get a cable with OBD Female connector at one end and other end open like the one shown on
the figure.
2. Get a DB9 Female connector.
3. Connect the pins as follows

DB9 PIN OBD Female Pin

3 GND 5
2 CAN L 14
7 CAN H 6

4. Now take out the connections to pins 16 and 4 of the OBD Female connector and attach a male
power connector. Pin 16 to the +ve terminal and Pin 4 to the –ve terminal.
5. Use a 12 V power supply and connect the power connector in the OBD cable to this supply
6. Connect the DB9 Female connector to CANMate

Now the cable is ready for ECUSim ! You can plug any OBD device which plugs to the OBD port
of the vehicle to the Female OBD connector in this setup and work with the Simulator.

You might also like