NWN - Scenario-Based Assignment v2 (2021) - Lab 6
NWN - Scenario-Based Assignment v2 (2021) - Lab 6
Intake : UCDF2005
Submission Date: 20th Nov 2021 [11:59 pm]
LEARNING OUTCOMES:
CLO3: Justify the topology and IP addressing plan based on the network design (A3,
PLO8)
Note: PLO8 – Personal Skills
SCENARIO
You are required to design and apply an IP addressing scheme for the topology shown for
Boulevard Hotels network in Figure 1. You will be given one class C block of IP addresses
that you must subnet and provide the IP addressing plan for the network. Using Packet Tracer,
you must first create the topology diagram of the network as shown in Figure 1. Once the
topology diagram is done, configure each device according to your proposed IP addressing
scheme. When the configuration is complete, use the appropriate commands to verify that the
network is working properly.
You are given the 192.168.200.0 address space to use in your network design. Prepare the
IPv4 addressing plan for this network following VLSM subnetting techniques.
(Note: Remember that the interfaces of routers also require IP addresses and are included in
the addressing scheme.)
**the remaining subnet requirements for WAN connection will be using public IPv4 addressing (/30)
1. There are total of 3 branch routers, and 1 offsite router for backup. All router to router
connections are using Serial interfaces.
2. LAN connection in the 3 branches - Kuala Lumpur (KL), Johor Bahru (JB) and Penang
are using copper cables (with Fast Ethernet interfaces)
3. There are wireless LAN connection provided in KL, JB and Penang branch using WiFi
technology.
4. Connection from Offsite router to the servers are using fiber optic cables (with
Gigabit Ethernet interfaces)
Draw the topology diagram in Cisco Packet Tracer, following the specific requirements
1. Perform basic configuration on Penang, JB, KL and Offsite routers to demonstrate the
following configuration skills:
2. Verify the network configuration by using PING and Tracert command. Troubleshoot
the network if any of your attempt is unsuccessful (failed).
Each student is required to provide an individual report to justify the network topology and IP
addressing scheme used in the network design. Relevant citation and referencing are to be used
to support the design.
1.0 Introduction
4.0 Conclusion
- Critical Evaluation (lesson learned) – reflections
5.0 References
Assignment Requirements
1 inch 1 inch
1 inch
1 inch
1 inch
1 inch 1 inch
*IMPORTANT*
You have to hand in your assignment (only softcopy) on time to the Online Submission System
(Moodle). The submission include:
Report
Softcopy of network design (in Cisco Packet Tracer)
Section B: CLO3: Justify the topology and IP addressing plan based on the network design (A3, PLO8) – Personal Skills