Chapter I Brief Introduction of YD-2-CK-FP01 I. Property of Products
1. 32-65536 level gray level control so that the image color and details could be truly reproduced.
2. 512 level three primary colors independent brightness control so that the accurate adjustment of white balance becomes more
simple and effective.
3. Hardware gamma correction function which is adjustable according to human physiological visual characteristics.
4. 100Hz refresh rate to ensure the stability of frames.
5. Ethernet interface and UDP networking protocol are applied. The maximum transmission range is 100m.
6. The display module timely displays the controller parameters and status.
7. Controller output includes both TTL and difference dual model.
8. Various chips control is integrated. Through software setting, parameters such as type of controller chip, clock frequency, OE
cycle, duty ratio, gray level, etc.
9. Dual network interface so that the cascade between the controllers could be realized.
II. Design Concept
1. synchronization control mode. Offline player could be added externally to realize offline play. This could be chosen
according to your requirement..
2. Video editing, displaying and wiring design software Easy Player (the company owns the proprietary intellectual property
rights) is applicable to various non-conventional type screen, multiple screen, text screen, pixel light screen etc..
3. The function of the software system is highly open and integrated. The display content and wiring design could be
independently finished by the user.
4. The operation of display software is easy to learn. The end user could self-design the display contents.
5. The data is directly received from the network card of the computers and the mode of dedicated display card + Master control
+ Branch control is abandoned. In this case, the installation becomes much easier and the cost will be much lower.
6. 3X and 4X virtual resolution is supported, which will improve the display effect enormously, or reduce the product cost
under the same display effect.
III. Extension
1. Videos and pictures with variable formats could be displayed synchronously or non-synchronously.
2. All fonts supported by Windows operating system could be displayed.
3. DMX512 lighting board could be connected to optional switch card, highly compatible with stage lighting system.
4. Pixel light with no drive circuit itself could be controlled through expanded drive board.
5. IP grouping function is supported to ensure the stability of several controllers in larger works. Hangzhou Yongdian Illumination Co., Ltd 6. Has 8 output ports.
Chapter II. Controller Model and Appearance
I. Product Model
1. YD-2-CK-FP01 synchronous controller and non-synchronous controller are industry type with casing and 8 output ports.
This can controlled pixel points could reach 682 (2048 lines) as usually.
I. Method for Connection with the Upper Part of the Machine (synchronous/online mode)
Directly connect to the computer network port
II. Offline Mode
Connect to the offline player
III. Order of lines at the output interface
5P terminals from left to right, signals from left to right Mode 1 2 3 4 5 General 950 GND DATA LE CLK OE 950 TTL Output 950 ķĸĹĺĻļĽľ GND A1 A2 B1 B2 485Output YD-2-CK-FP01 output interface include 8 5P ports, from 1 to 950DMX GND A B 8 (shown as above) Hangzhou Yongdian Illumination Co., Ltd
Č. Simple Sample Installation Instructions and Schematic Diagram
In the following, 16mX6m rectangle display laid by 16 segment digital tubes is taken as the sample for introducing the connection lines of YT-S950 as shown in the diagram below. 160 rows, 6 tubes in each row laid vertically. Each interface of the controller controls 5 rows of tubes (480 pixel points). A total of 32 SPI ports are needed.
… … …
…… …
XS02/Computer (Optional) FP01 FP01 FP01
Hangzhou Yongdian Illumination Co., Ltd Chapter Č Attentions Order of Network Cables 568A: Green white Green Orange white Blue Blue white Orange Brown white Brown 568B:Orange white Orange Green white Blue Blue white Green Brown white Brown The controller, offline player and switch should be connected by cross ruling, i.e., one end is 568A and the other end is 568B.
Straight through line should be adopted for any of the above equipment and the computer, i.e. both sides are 568A or 568B. It is
forbidden to self-define the order of straight through line.
Lines from the controller to the lamps & lanterns and connection method
1.950TTL output, it is suggested to choose category V line or above as the signal line. The best way of connection to the signal
line of lamps & lanterns is as below:
Orange——Data Green——Clock Blue——Lock Brown——OE All other colored lines are connected to GND of the
signal line.
It is forbidden to use two winded up line to connect the signal at the same time, e.g. connect Orange and Orange white to Data
as the same time.
2. 950 difference output. This mode is only applicable to double signal or single signal lamps & lanterns, i.e. the ones with
only Data or with Data and Clock.
It is suggested to choose category V line or above as the signal line. The best way of connection to the lamps & lanterns or
difference converter plate is as below:
Using two winded up lines, one is A and the other is B, e.g. Orange is A and Orange white is B.
3. Shielded twisted pair is generally used for 950DMX. The signal line should be grounded. At the end of each signal line, i.e.
between A and B, a 120R terminal resistance should be added.
ILUMINACIÓN DECORATIVA PROGRAMABLE
PROYECTO TORRE DEL CABLE Manizales
PROYECTO TORRE DEL CABLE Manizales ILUMINACIÓN DECORATIVA PROGRAMABLE
