Scribd
Upload
19 views1 page

Configuring The Station Connection Properties On The Console Station

The document provides instructions for configuring LEDs on an operator keyboard to associate with alarm points and describes configuring connection properties for a station on a console station, including setting the connection type and window mode.

Uploaded by

Miguel P.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
19 views1 page

Configuring The Station Connection Properties On The Console Station

The document provides instructions for configuring LEDs on an operator keyboard to associate with alarm points and describes configuring connection properties for a station on a console station, including setting the connection type and window mode.

Uploaded by

Miguel P.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

associated operator keyboard LED shows the highest priority alarm.

You only need to do this task if you are using either the IKB or the OEP keyboard.
Prerequisites
• You have installed the appropriate drivers and connected the keyboard. For these instructions, see : Experion
R410 > Installation and Upgrades > Supplementary Installation Tasks Guide > Installing specialized
hardware on a computer.
To configure LEDs
1 In the Configuration Explorer in Configuration Studio, click Stations and Consoles.
2 Click the Configure Console Stations task.
The Console Station Configuration Summary display appears in the System Display tab in Configuration
Studio.
3 Click Console Station for which you want to configure LEDs to call up the Console Station Configuration
display.
4 Click the Operator Keyboard tab.
5 For every LED you want to associate with a point, type the point ID in the corresponding LED key number
box.
Configuring the Station connection properties on the Console Station
The Station on a Console Station can operate in single mode or multi-window mode. If you are using multiwindow
mode, there are special configuration tasks you need to complete.
This procedure covers settings required specifically for a Station on a Console Station. There are other settings
you can set that are applicable to any type of Station.
To configure Station connection properties on a Console Station
1 Start the Console Station.
2 Choose Start > All Programs > Honeywell Experion PKS > Console Station > Station.
3 Choose Station > Connect.
The Connect dialog box opens.
4 Select default.stn and click Edit.
The Connection Properties dialog box opens.
5 Click the Console Station connection type.
6 In the Console Station list leave the default setting as localhost.
7 In the Station Number box, leave the default setting as 1.
8 Click the required window mode.

You might also like