Physics Practical QP
Physics Practical QP
Q.1)Suspend a light pan from the lower end of the spring suspended vertically from a rigid support. Set
the system consisting of suitable mass in the pan and determine the time taken to complete a
suitable number of oscillations. Vary the mass in the pan and find time of oscillations for five
different values of mass M .Find periodic time for each mass assuming whole mass ( m s +M) of
the system concentrated at a single point .(Mass of the spring is m s )
8M
Q.2 A] Use of digital multimeter i) Identify base of transistor ii) identify given transistor is NPN or PNP
transistor.
4M
B] find the dissipation of energy of simple pendulum by plotting a graph between square of
amplitude and time.
4M
Q.1)You are given five tunning forks of known frequencies. Keeeping tension constant determine length
of the wire vibrating in unison with each tunning fork.hence verify the law of length. 8M
Q.2 A] Find the effect of load of depression of a suitable clamped meter scale loaded at its end. 4M
B] Identify given electronic component.
Q.1) A tunning fork of known frequency is given to you. Using sonometer the length (L) of the wire
vibrating in unison with given tunning fork for four different known tension (T) and
unknown tension.
Plot a graph of L2 against T. Hence determine unknown tension. Also draw the conclusion from the
graph.
8M
Q.2 A] Use of digital multimeter i) Identify base of transistor ii) identify given transistor is NPN or PNP
transistor.
4M
B] find the dissipation of energy of simple pendulum by plotting a graph between square of
amplitude and time.
4M
Q.1) A set of five tunning forks of known frequencies is given to you. Find correct length of air column
vibrating in unison with each tunning fork. Plote graph 1/L against frequency (n).
Q.2 A] Find the effect of load of depression of a suitable clamped meter scale loaded at its end. 4M
Q.1) Determine the resistance of a given wire using Wheastone’s meter bridge. Take three independent
sets of readings. Also interchanging the position of wire and resistance box in the gaps.
i)Length of wire=………..m
Q.2 A] Find the effect of load of depression of a suitable clamped meter scale loaded at its end. 4M
Q.1) Determine the resistance of the galvanometer by kelvin’s method . Take three independent
readings. Repeat the experiment by interchanging the posions of the galvanometer and the
resistance box. 8M
Q.2 A] Use of digital multimeter i) Identify base of transistor ii) identify given transistor is NPN or PNP
transistor.
4M
B] find the dissipation of energy of simple pendulum by plotting a graph between square of
amplitude and time.
4M