Scribd
Upload
217 views1 page

Installation and Startup Guide Envision For Bactalk: Task See

Uploaded by

Kdc Ouinbilo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
217 views1 page

Installation and Startup Guide Envision For Bactalk: Task See

Uploaded by

Kdc Ouinbilo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Installation and Startup Guide | Envision for BACtalk

Quick steps–upgrading single operator workstation sites

Task See
1 Save Point Data and Device Configuration in Device Manager. page 58

2 Back up the existing job. page 18

3 Close the current BACtalk operator workstation software (BACtalk page 19


for Windows or Envision for BACtalk).

4 Compact the existing job database (Start > Programs > Alerton > --
Envision for BACtalk v1.x > Compact BACtalk Access Database).
Note: Shut down Envision for BACtalk before compacting the
database.

5 Run setup.exe from the Envision for BACtalk v2.6 CD-ROM. page 20
Note: Default installation location for v2.6 is C:\Alerton\BACtalk\2.6.
This is a different location than the BACtalk for Windows default
location. Caution: Do not overwrite BACtalk for Windows unless
you no longer need it.

6 Install the hardware key driver. page 21


Note: Setup prompts you to install the driver at the end of the
installation process. Or, you can choose Install Hardware Key Driver
from the Alerton program group.

7 Start Envision for BACtalk v2.6 and log in. page 32

8 If necessary, restore the job you backed up in step 2. page 36


9 Restart Envision for BACtalk, and log into the job. --

10 Verify General System Setup. page 41


• On the Identification tab, set the device instance, device name and
device description for the operator workstation.
• On the Network tab, verify the Primary Ethernet adapter.
• Verify that either the Ethernet BACnet Protocol or Annex J
BACnet/IP is enabled. Caution: Do not enable both.
• Verify the Client/Server Communications Protocol setting.
• Configure the site BACtalk client/server and host device.
• Configure the database options for Enterprise servers.
• If converting to an Enterprise server, restart BACtalk to convert the
databases from Access/Jet to SQL Server format.

11 Upgrade the ROC file in all host devices. page 24

12 © Honeywell. All Rights Reserved. LTBT-TM-ADMIN26 Rev. A

You might also like