EVL6562A-TM-80W

80 W high performance transition mode PFC evaluation board

Data Brief

Features
■ Line voltage range: 88 to 265 VAC
■ Minimum line frequency (fL): 47 Hz
■ Regulated output voltage: 400 V

( s )
ct
■ Rated output power: 80 W
■

■
Maximum 2fL output voltage ripple: 10 V pk-pk
Hold-up time: 20 ms (VDROP after hold-up time:
d u
300 V)
ro
■ Minimum switching frequency: 35 kHz
e P
■ Minimum estimated efficiency: 92% (VIN = 90
VAC, POUT = 80 W)
l e t
■ Maximum ambient temperature: 50 °C
so
■ PCB type and size: single side, 35 µm, CEM-1,
108 x 57 mm
O b
) -
Description
The L6562A is a current-mode PFC controller
c t (s
d u
operating in transition mode (TM). With the same

r o
pin-out as its predecessor L6562, the L6562A
offers improved performance mainly in terms of
P
efficiency and noise immunity.
e
l e t
This board implements an 80 W, wide-range
mains input and a PFC pre-conditioner suitable

s o
for ballast, adapters, flat screen displays, etc.

O b

October 2007 Rev 2 1/6

For further information contact your local STMicroelectronics sales office. www.st.com 6
Electrical specification and performance EVL6562A-TM-80W

1 Electrical specification and performance

Figure 1. EVL6562A-TM-80W schematic

Vo=400V
D1 NTC
STTH1L06 2.5 Ω Po=80W

T1
R4 R5 D8 C5 R14
270 kΩ 270 kΩ 1N4148 10 nF 100 Ω R11
1M Ω

D2 R50 - 22 kΩ
R1 R12
1 MΩ 1N5248B
R6 1M Ω
C3 - 2200 nF
47 kΩ
C1
P1 C23
0.22 µF ZCD COMP 150 nF INV
F1 + W08
630V C6

)
4A/250V R2 VCC
1 MΩ 8 5 2 1 R7 47 µF

s
33 Ω 450V
MULT GD Q1

(
Vac - 3 L6562A 7

ct
STP8NM50FP
88V
to 6 4 R8
264V 47k Ω

u
C2 GND CS R15

d
10nF C29
R3 C4 SHORTED
22 µF

o
15 kΩ 100 nF R9 R10
25V R13 R13B

r
0.68 Ω 0.68 Ω 15 kΩ 82 kΩ
0.25W 0.25W

Boost Inductor Spec (ITACOIL E2543/E)

e P
t
E25x13x7 core, N67 ferrite
1.5 mm gap for 0.7 mH primary inductance
Primary: 102 turns 20x0.1 mm
Secondary: 10 turns 0.1 mm

o l e
b s
Table 1. Bill of material
Part type / part
- O
Des.
value

(s ) Description Supplier

F1 Fuse 4 A
ct
Fuse T4A - time delay Wichmann

du
P1 W06 600 V-1 A Single phase bridge rectifier Chenyi electronics
C1 220 NF-630 V
r o B32653-A6224-K - film capacitor Epcos
C2 10 NF

e P 50 V cercap - general purpose Avx

C3
C4
2u2F

l e t
100NF
SR305E225MAR - 50 V ceramic capacitor - Z5U
50 V cercap - general purpose
Avx
Avx
C5
s o 10NF 50 V cercap - general purpose Avx

Ob
C6 47 µF-450 V aluminium elcap - ED series - 85°C Daewoo
C23 150NF 50 V cercap - general purpose Avx
C29 22 µF-50 V aluminium elcap - YK - 85°C Rubycon
R1 1M0 MBB0207 axial film res - 0.4 W - 1% - 50 ppm/°C BC Components
R2 1M0 MBB0207 axial film res - 0.4 W - 1% - 50 ppm/°C BC Components
R3 15 K MBB0207 axial film res - 0.4 W - 1% - 50 ppm/°C BC Components
R4 270 K SFR25 axial stand. film res - 0.4 W - 5% - 250 ppm/°C BC Components
R5 270 K SFR25 axial stand. film res - 0.4 W - 5% - 250 ppm/°C BC Components
R6 47 K SFR25 axial stand. film res - 0.4 W - 5% - 250 ppm/°C BC Components
R7 33R SFR25 axial stand. film res - 0.4 W - 5% - 250 ppm/°C BC Components

2/6
 EVL6562A-TM-80W Electrical specification and performance

Table 1. Bill of material (continued)

Part type / part
Des. Description Supplier
value

R8 47 K SFR25 axial stand. film res - 0.4 W - 5% - 250 ppm/°C BC Components

R9 0R68 SFR25 axial stand. film res - 0.4 W - 5% - 250 ppm/°C BC Components
R10 0R68 SFR25 axial stand. film res - 0.4 W - 5% - 250 ppm/°C BC Components
R11 1M0 MBB0207 axial film res - 0.4 W - 1% - 50 ppm/°C BC Components
R12 1M0 MBB0207 axial film res - 0.4 W - 1% - 50 ppm/°C BC Components
R13 15 K MBB0207 axial film res - 0.4 W - 1% - 50 ppm/°C BC Components
R13B 82 K MBB0207 axial film res - 0.4 W - 1% - 50 ppm/°C BC Components

( s )
ct
R14 100 R SFR25 axial stand. film res - 0.4 W - 5% - 250 ppm/°C BC Components
R15 Shorted Tinner wire jumper
R50 22 K
d u
SFR25 axial stand. film res - 0.4 W - 5% - 250 ppm/°C BC Components
D1 STTH1L06 Ultrafast high voltage rectifier
r o
STMicroelectronics
D2 1N5248B 18V-0.5W zener diode
e P Fairchild
D8 IN4148 fast switching diodE
l e t Vishay
NTC1 2R5-S237 B57237S0259M000
s o Epcos
T1
U1
E2543/E
L6562A
E25x13x7 core, 0.7 mH

O
Transition mode PFC controller
b Itacoil
STMicroelectronics
Q1 STP8NM50FP
) -
n-channel md-mesh Power MOSFET STMicroelectronics
HS1 FK218 32
t (s
Q1 heat sink for TO-220 - 21 °C/W

c
Fischer elektronik
J1 MKDS 1,5/
u
PCB term. block, screw conn., pitch 5 mm - 3 W. Phoenix contact

od
J2 MKDS 1,5/ PCB Term. block, screw conn., pitch 5 mm - 3 W. Phoenix contact

Pr
F1 Fuse 4 A Fuse T4A - time delay Wichmann
P1 W06

e t e 600 V-1 A single phase bridge rectifier Chenyi electronics

s ol
O b

3/6
 Electrical specification and performance EVL6562A-TM-80W

Figure 2. EVL6562A-TM-80W: efficiency vs Figure 3. EVL6562A-TM-80W: static Vout

Vin regulation vs Vin
404
100

403.5

95
403
Pout = 80W
EFFICIENCY (%)

402.5
90

Vout (Vdc)
402
Pout = 80W
85
401.5

)
401
80

( s
ct
400.5

75
80 100 120 140 160 180 200 220 240 260 400

du
80 100 120 140 160 180 200 220 240 260
Vin (Vac)
Vin (Vac)

r o
Figure 4. EVL6562A-TM-80W: PF vs Vin Figure 5. P
EVL6562A-TM-80W: THD vs Vin
e
e t
ol
1.00 12

0.95
b s 10

- O 8

)
THD (%)
PF

0.90 Pout = 80W

(s
6

ct
4

du
0.85
Pout = 80W
2

0.80
r o
P
0
80 100 120 140 160 180 200 220 240 260 80 100 120 140 160 180 200 220 240 260

e
Vin (Vac) Vin (Vac)

e t
s ol
O b

4/6
 EVL6562A-TM-80W Revision history

2 Revision history

Table 2. Document revision history

Date Revision Changes

07-Aug-2007 1 Initial release

11-Oct-2007 2 Document reformatted no content change

( s )
u ct
o d
P r
e t e
o l
b s
- O
(s )
c t
du
r o
e P
l e t
s o
O b

5/6
 EVL6562A-TM-80W

Please Read Carefully:

( s )
u ct
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the

time, without notice.

o d
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any

All ST products are sold pursuant to ST’s terms and conditions of sale.
P r
t e
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.

e
o l
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products

b s
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.

- O
(s )
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED

c t
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.

d u
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING

r o
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,

P
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.

e t e
o l
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any

s
liability of ST.

b
O ST and the ST logo are trademarks or registered trademarks of ST in various countries.

Information in this document supersedes and replaces all information previously supplied.

The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.

© 2007 STMicroelectronics - All rights reserved

STMicroelectronics group of companies

Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com

6/6