Fog Machine: Owner S Manual
Fog Machine: Owner S Manual
Fog Machine: Owner S Manual
Owner‘s Manual
FOG MACHINE
Thank you for choosing one of our fog machines. You now own a rugged
and powerful state-of-the-art machine. Prior to use, we suggest that you
carefully read all of the instructions. By following the suggestions found
in this user manual, you can look forward to the reliable and satisfactory
performance of your fog machine for years to come.
1. Cautions
For your own safety you must read this section in full
first!
3. Setup
• Remove all packing materials from shipping box, check that all foam
and plastic padding is removed, especially in the nozzle area.
• Place the fog machine on a flat surface and remove liquid tank cap.
• Pour high quality fog water-based liquid into the liquid tank, being
careful not to exceed the maximum fluid level. DO NOT OVERFILL. Use
only our Fogger Liquid or other dealer-recommended high-quality fog
fluid. Any other types of fluid can damage the unit. When the container
is full, place the cap back on the liquid tank and tighten.
• Firmly attach remote control cable to the proper input on the rear of the
machine.
-3-
4. Operation
• Plug the power cord into a properly wired and grounded electrical outlet.
Turn the power switch on rear of unit to position “ON”.
• Once the red light comes on the machine must warm-up .This period
varies depending on conditions but should not take more than 10
minutes under any circumstances.
• The green light on the remote control will turn on once the machine is
ready to produce haze. When the green light turns on, the machine may
be operated using the remote control. Prior to the green light turning on
the machine will not haze and the functions will not respond.
• The fog machine is controlled via the remote control. Please refer to the
section titled Remote Control Operation for detailed instruction on the
various functions available.
• The remote unit’s lamp will cycle on and off as the machine re-heats to
the proper operating temperature.
• As your model includes a mounting bracket designed for overhead
installation, it may be installed at floor level or suspended overhead. If
the unit is to be mounted using the bracket, it is important that the fog
does not shoot directly at any one’s face. Whatever installation method
you choose, do not allow the unit to have more than a 15 degree angle
of inclination.
Important:
Always monitor tank fluid level during operation. The fog machine can
suffer damage when run without fluid. If the machine does not function after
having been run without fluid, please contact your Fogger dealer for service.
Fog Liquid
• The fog machine operates on regular fog liquid. The machine has been
designed to produce exceptional haze using Stairville fog liquids. Use
only our high quality fog liquids or other dealer recommended fog fluids.
Failure to use high quality fog liquid can damage the machine.
• The Fogger can only be operated using fog fluids or fluids
recommended by your dealer that are designed to be used exclusively
in the fog machine.
• Do not allow the fog liquid to become contaminated. Contamination
includes adding fragrances, oils, dust or any other foreign materials to
the fog liquid supply. Always replace the caps on the fog liquid container
and the Fogger’s liquid tank immediately after filling.
5. Cleaning
After every 40 hours of continuous operation, we recommended to run
a cleaning solution composed of 80% distilled water 20% white vinegar
through the system to prevent the accumulation of particulate matter in the
heating element. Please follow these guidelines:
1. While the unit is unplugged and cooled down, unscrew the nozzle at
the very front of the unit and clean out debris with vinegar and a pipe
cleaner, making sure that the hole is free of clogs.
2. Empty all fog fluid from the machine. Add cleaning solution to the tank.
Plug the unit in and let it warm up.
3. Run the unit in a well-ventilated area, until the tank is empty.
4. Replace the nozzle.
5. Cleaning is now completed, refill with fog liquid.
6. Troubleshooting
If you experience low output, pump noise or no output at all, unplug the unit
immediately. Check the fluid level, the external fuse, remote connection,
and power from the wall outlet. If all of the above appears to be O.K., plug
the unit in again. If fog does not come out after holding the remote button
down for 30 seconds, check the hose attached to the tank to make sure
there is fluid going through the hose. If you are unable to determine the
cause of the problem, do not simply continue pushing the remote button,
as this may damage the unit. Return the machine to your dealer.
-5-
WARNING!
XX Never block ventilation holes!
XX Never touch the unit when it‘s hot!
XX No user serviceable parts inside. Refer to your Fogger dealer
or other qualified service personnel.
7. Specification
Rating Voltage: 220-240V~/50Hz
Power: 1000W
Fuse: 5A/250V
Tank capacity: 1,5 Liter
Dimensions: 430 x 220 x 140 mm
Weight: ca. 8 kg
As we continuously strive to improve our products, all specifications and
appearance are subject to change without prior notice.
Keep this manual for future reference.
8. Disposal
Do not dispose of the device at the end of his operating life
in your normal domestic waste. This device is subject to
the European Guidelines 2002/96/EC.
-6-
-7-
Contact:
Musikhaus Thomann
Treppendorf 30
96138 Burgebrach
Germany
www.thomann.de