Corrected Answers - Chinese Vs 9TUT Mismatched Answers

https://t.
me/techvortex
Correct answers
for Chinese and 9TUT dump mismatched Questions
Telegram Group ->

https://t.me/techvortex
YouTube Chanel ->
https://www.youtube.com/c/TECHVORTEXX
Thanks for Youssef

our group member for providing the base for the review
process.
1|Page
This document was created on 7 September 2021
Correct Answers in 9TUT Dump, Wrong in Chinese

Question 1
Explanation
- Dynamic routing means the ability of learning routes automatically, and fast
onboarding for new networks, as well as fault tolerance and availability through self-
learning of routing table based on protocols such as OSPF, RIP, EIGRP, BGP, IS-IS
- Dual Homed means to connect with one service provider over two different links.
Question 2
Explanation
- If no IP address configured on the port, for example the switch port, the
CDP report the IP address of the switch management vlan, you can test
this concept using packet tracer.
2|Page
Question 3
Explanation
- When using extend trust command, IP phone will not reset COS value in
frame received from PC and will send it as it is to the switch port.
Question 4
Explanation
- Desirable and Desirable = Trunk
3|Page
- Desirable and Auto = Trunk

- Trunk and Auto = Trunk
- B and D lead to same result, but D is the best answer as Desirable is
more powerful than auto, also keep in mind that the command is
“switchport mode dynamic desirable”
Question 5
Explanation
- Same as question 4 answer
Question 6
Explanation
4|Page
- Portfast is used with network ports connected to workstations and

users, it allows network connection to be immediately established once
the cable plugged.
- Uplink fast is a feature related to spanning tree, it allows fast
convergence of network in case one of uplinks to upstream switch failed.
Question 6
1 6
2 3
3 1
4 2
5
4
6
5
Explanation
Memorize the following: -
- Monitor mode receive only, never transmit
- Flex-Connect is used when AP in different network other than the
wireless controller
- Capturing = Sniffing (then sniffer mode for capture)
- Local mode transmits on single channel and monitor the other
5|Page
Question 7
Explanation
- Public cloud is maintained by single party, for example google, but it is
available to access by multiple organization, in fact, anyone can use the
public cloud services “Gmail, YouTube, OneDrive, etc.”
- Public cloud services are accessible through internet
- Network resources in public cloud is fully owned by the cloud service
provider, Hybrid-cloud may include the combination of using 3rd party
resources and privately-owned resources.
6|Page
Correct Answers in Chinese Dump, Wrong in 9TUT
Question 1
Explanation
- The request is to provide IP address for 8 floors, with 30-40 user at each
floor, then total users is (40 * 8 = 320 users), the subnetwork that can
support this number of users is 192.168.0.0 255.255.254.0 or CIDR /23,
as this mask support up to 510 hosts.
- Using 255.255.255.224 or CIDR /27 per floor will not suffice the need, as
it supports maximum of 30 hosts, and the question state that 30-40
users, so using it will not be scalable.
- 255.255.255.128 or CIDR /25 will support 126 host in the network, so it
is waste of resources.
7|Page
Question 2
Explanation
- We apply virtualization to decouple or segment physical hardware to
virtual CPU, Memory disk to create virtual machines.
- Hypervisor is what is responsible for management and allocation of host
hardware resources.
Question 3
Explanation
- EF or expedited forwarding is used for marking and to tag the voice
packets.
- LLQ or Priority queuing is prioritization method, it uses the EF tag on
packets to present priority to VOIP traffic.
8|Page
-
Question 4
Explanation
- To disable cdp on port, use no cdp enable under this port
- To disable cdp on device itself “all ports”, use no cdp run
9|Page
Question 5
Explanation
- Full explanation
https://success.trendmicro.com/solution/TP000086250-What-are-
Syslog-Facilities-and-Levels
Question 6
Explanation
- To setup FHRP communication, the routers in same group must be in the
same broadcast domain “subnet”, this allows them to communicate the
protocol related packets “Such as hello”, these protocols used multicast.
10 | P a g e
Question 7
Explanation
- The question grammar is tricky, it requires to configure encrypted
password for enable, in this case enable secret will setup the required
encrypted password.
- Service password encryption, encrypt enable password to type 7 format,
this encryption format can easily be cracked, so enable secret is the best
answer.
Telegram Group ->

YouTube Chanel ->
https://www.youtube.com/c/TECHVORTEXX
11 | P a g e

Corrected Answers - Chinese Vs 9TUT Mismatched Answers

Uploaded by

Copyright:

Available Formats

Corrected Answers - Chinese Vs 9TUT Mismatched Answers

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Corrected Answers - Chinese Vs 9TUT Mismatched Answers

Uploaded by

Copyright:

Available Formats

https://t.

Telegram Group ->

Thanks for Youssef

Correct Answers in 9TUT Dump, Wrong in Chinese

- Desirable and Auto = Trunk

- Portfast is used with network ports connected to workstations and

Correct Answers in Chinese Dump, Wrong in 9TUT

Telegram Group ->

You might also like