Scribd
Upload
68 views3 pages

NTE31000 IR Receiver Module For Remote Control Systems: Description

The NTE31000 is an infrared receiver module used in remote control systems. It contains a photo detector and preamplifier in a single epoxy package that acts as an infrared filter. The module operates with a low supply current between 2.5-5.5V and outputs a demodulated signal that can be directly decoded by a microprocessor. It is compatible with common infrared data formats but has not been qualified for automotive use.

Uploaded by

HECTOR FABIAN OROZCO GARCIA
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
68 views3 pages

NTE31000 IR Receiver Module For Remote Control Systems: Description

The NTE31000 is an infrared receiver module used in remote control systems. It contains a photo detector and preamplifier in a single epoxy package that acts as an infrared filter. The module operates with a low supply current between 2.5-5.5V and outputs a demodulated signal that can be directly decoded by a microprocessor. It is compatible with common infrared data formats but has not been qualified for automotive use.

Uploaded by

HECTOR FABIAN OROZCO GARCIA
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

NTE31000

IR Receiver Module for Remote Control Systems

Description:
The NTE31000 is a miniaturized receiver for infrared remote control systems. A PIN diode and a
preamplifier are assembled on a lead frame, the epoxy package acts as an IR filter.
The demodulated output signal can be directly decoded by a microprocessor. The NTE31000 is com-
patible with all common IR remote control data formats, primarily older AGC2 designs.
This component has not been qualified according to automotive specifications.

Features:
D Very Low Supply Current
D Photo Detector and Preamplifier in One Package
D Internal Filter for PCM Frequency
D Improved Shielding Against EMI
D Supply Voltages: 2.5V to 5.5V
D Improved Immunity Against Ambient Light
D Insensitive to Supply Voltage Ripple and Noise

Absolute Maximum Ratings:


Supply Voltage, VS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −0.3 to +6V
Supply Current, IS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3mA
Output Voltage, VO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −0.3 to (VS +0.3)V
Output Current, IO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5mA
Power Consumption (TA £ +85°C), Ptot . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10mW
Operating Junction Temperature, TJ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +100°C
Operating Temperature Range, TA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −25° to +85°C
Storage Temperature Range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −25° to +85°C
Soldering Temperature (t £ 10s, 1mm from case), Tsd . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +260°C
Note 1. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent
damage to the device. This is a stress rating only and functional operation of the device at
these or any other conditions beyond those indicated in the operational sections of this speci-
fication is not implied. Exposure to Absolute Maximum Rating conditions for extended peri-
ods may affect the devices reliability.
Electrical and Optical Characteristics: (TA = 25°C unless otherwise specified)
Parameter Symbol Test Conditions Min Typ Max Unit
Supply Current ISD EV = 0, VS = 3.3V 0.27 0.35 0.45 mA
ISH EV = 40klx, sunlight − 0.45 − mA
Supply Voltage VS 2.5 − 5.5 V
Transmission Distance d EV = 0, IF = 250mA − 45 − m
Output Voltage Low VOSL IOSL = 0.5mA, Ee = 0.7mW/m2 − − 100 mV
Minimum Irradiance Ee min. Note 2 − 0.15 0.35 mW/m2
Maximum Irradiance Ee max. Note 2 30 − − W/m2
Directivity j1/2 Angle of half transmission distance − ±45 − deg.

Note 2. Pulse Width Tolerance: tpi − 5/fo < tpo < tpi + 6/fo

Suitable Data Format:


The NTE31000 is designed to suppress spurious output pulses due to noise or disturbance signals.
Data and disturbance signals can be distinguished by the devices according to carrier frequency,
burst length and envelope duty cycle. The data signal should be close to the band−pass center fre-
quency (e.g. 38kHz) and fulfill the conditions in the table below.
When a data signal is applied to the IR receiver in the presence of a disturbance signal, the sensitivity
of the receiver is reduced to insure that no spurious pulses are present at the output. Some examples
of disturbance signals which are suppressed are:
D DC light (e.g. from tungsten bulb or sunlight)
D Continuous signals at any frequency
D Strongly or weakly modulated noise from fluorescent lamps with electronic ballasts
Minimum burst length 10 cycles/burst
After each burst of length 10 to 70 cycles
a minimum gap time is required ³ 10 cycles
For bursts greater than 70 cycles
a minimum gap time in the data stream is needed of > 4 x burst length
Maximum number of continuous short burst/second 1800
Recommended for NEC code Yes
Recommended for RC5/RC6 code Yes
Recommended for Sony code Yes
Recommended for Thomson 56kHz code Yes
Recommended for Mitsubishi code (38kHz, preburst 8ms, 16 bit) Yes
Recommended for Sharp code Yes
Suppression of interference from fluorescent lamps Most common disturbance
signals are suppressed
.197 (5.0) .189 (4.8)

.157 (4.0) .110 (2.8)


.110 (2.8) R

.274
(6.95)
.325
(8.25) .219
(5.55)

1.181
(30.0)
Min

OUT VS
GND

.100 (2.45) .100 (2.45) .047 (1.2)

You might also like