Scribd
Upload
44 views2 pages

Quiz

This document contains a two-question quiz for a product design and manufacturing course. Question 1 involves calculating the mold constant in Chvorinov's Rule and determining the solidification time for a cylindrical casting using the same alloy and mold. Question 2 asks the student to calculate the diameter needed at the bottom of a 300mm long sprue with a 125mm top diameter to achieve a 650mm3/s flow rate, and determine if the sprue will aspirate. The quiz is out of 20 total points and was administered on March 30, 2021.

Uploaded by

Anas Tubail
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
44 views2 pages

Quiz

This document contains a two-question quiz for a product design and manufacturing course. Question 1 involves calculating the mold constant in Chvorinov's Rule and determining the solidification time for a cylindrical casting using the same alloy and mold. Question 2 asks the student to calculate the diameter needed at the bottom of a 300mm long sprue with a 125mm top diameter to achieve a 650mm3/s flow rate, and determine if the sprue will aspirate. The quiz is out of 20 total points and was administered on March 30, 2021.

Uploaded by

Anas Tubail
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Student Name: Date: 30/03/2021

Islamic University of Gaza


Faculty of Engineering Time: 30 Minutes
Industrial Engineering Department
Student Number: Total points: 20
EIND 5053: Product Design and Manufacturing
Quiz #2
Eng. Amr Matar

Q1) Solve (10 Points)

In casting experiments performed using a certain alloy and type of sand mold, it took 155
seconds for a cube-shaped casting to solidify. The cube was 50 mm on a side.

(a) Determine the value of the mold constant in Chvorinov's Rule.


(b) If the same alloy and mold type were used, find the total solidification time for a
cylindrical casting in which the diameter = 15 mm and length = 50 mm.
‫ــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــ ـــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــ‬

1
Second Quiz EIND 5053: Product Design and Manufacturing

Q2) Solve (10 Points)

A sprue is 300 mm long and has a diameter of 125 mm at the top. The molten metal level
in the pouring basing (which is much larger than the top of the sprue) is taken to be 75 mm
from the top of the sprue for design purposes. If a flow rate of 650 mm3/s is to be achieved,
what should be the diameter at the bottom of the sprue? Will the sprue aspirate? Explain.
‫ــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــ ـــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــ‬

Good Luck

You might also like