Freshwater Aquaculture: Advantages Disadvantages
Freshwater Aquaculture: Advantages Disadvantages
Freshwater Aquaculture: Advantages Disadvantages
RAS
RAS SYSTEM DESIGN
During the growout phase you need to feed your fish and maintain favorable
environmental conditions.
The best growth occurs when water chemistry is maintained within an optimal
range. For tilapia, the recommended water chemistry values are as follows:
System design should be approached in a reverse manner. The final desired fish size and
total weight of the harvest is determined, a maximum fish density is established, and
assumptions about mortality rate are applied to arrive at initial stocking numbers. Maximum
density dictates the maximum daily feed rate, which is usually 1.0 to 1.5 percent of the
biomass for market-size fish of 1.5 pounds (680 grams) each. This biomass density (lbs/gal or
kg/m3) is a design parameter that is highly dependent upon the type and size of filtration
technology used. Efficient solids filtration makes it possible to use higher feed rates and still
keep the system operating within safe limits of dissolved oxygen, dissolved ammonia, pH
and suspended solids.
FISH MANAGEMENT
Tilapia are commonly bred in tanks. Brood fish are stocked at a rate of 0.06 to 0.14 pound of
brood fish per square foot (0.29 to 0.68 kg/m2) of tank bottom. They produce
approximately 0.14 to 0.23 fry per square foot (1.5 to 2.5/m2) per day. Within 10 to 15 days
after stocking brood fish, newly hatched fry can be captured with a dip net and transferred
to a nursery unit. Fry that avoid capture prey on subsequent spawns and reduce production.
After 1 to 2 months, the tank must be drained to remove all juvenile fish and begin another
spawning cycle. Breeding can be better controlled when net enclosures (hapas) are floated
in tanks. Male and female brood fish, which have been kept apart, are stocked into the hapa
to begin breeding. A sex ratio of two females to one male is used to produce large quantities
of fry. The optimum stocking density ranges from 0.5 to 1.0 fish per square foot (5.4 to
10.8/m2). Small brood fish (0.25 lb, 115 grams) make handling easier, although larger brood
fish may be used. The brood fish are fed high-quality feed at a rate of 2.0 percent of their
body weight per day.
To ensure that targeted growth rates are achieved for a given week, the manager will
estimate the beginning and ending biomass of the tank based upon estimated growth rates,
assume a realistic FCR, and calculate the total amount of feed required for that week. For
example, if a growth rate of 5.0 grams per day per fish is expected and the tank contains
10,000 fish, a total of 350,000 grams (350 kg) of weight should be gained for the week.
Assuming an FCR of 1.7:1, the manager would need to feed 595 kg of feed for the week (1.7
x 350 kg = 595 kg). The daily feed rate would have to average at least 85 kg (595 kg ÷ 7
days/week = 85 kg). If that feed rate cannot be reached, the manager should look for an
explanation so the problem can be remedied. Often poor water quality is the cause of the
problem. The fish may not be eating aggressively due to the stresses of high ammonia
levels, nitrite toxicity, low dissolved oxygen, high levels of carbon dioxide, or other water
quality problems.
PRODUCTION SYSTEMS VIABILTY
Check this site out
http://www.fish-farm.co.za/farminabox-menu/