Scribd
Upload
139 views20 pages

Structural Analysis AND Design Computation

This document summarizes the structural analysis and design computation for proposed alterations to a one-storey residential building. It outlines the design methodology, loads, criteria, and parameters to be used, including dead loads, live loads, seismic and wind design considerations. The structural model and analysis results will be input and output from STAAD, with manual computations also to be performed.

Uploaded by

Jheo Torres
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
139 views20 pages

Structural Analysis AND Design Computation

This document summarizes the structural analysis and design computation for proposed alterations to a one-storey residential building. It outlines the design methodology, loads, criteria, and parameters to be used, including dead loads, live loads, seismic and wind design considerations. The structural model and analysis results will be input and output from STAAD, with manual computations also to be performed.

Uploaded by

Jheo Torres
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 20

STRUCTURAL ANALYSIS

AND
DESIGN COMPUTATION

PROJECT: PROPOSED ONE-STOREY RESIDENTIAL ALTERATION


LOCATION: GOLD ST., RICHLAND SUBDIVISION, BRGY. SAUYO, QUEZON CITY
OWNER: MRS. MARITES ANASTACIO
STRUCTURAL MODEL
DESIGN METHODOLOGY:
ULTIMATE STRENGTH DESIGN
DESIGN LOADS:
Dead Loads
1. Selfweight

Concrete Unit weight = 24 kN/m3

2. Member Load

150 mm CHB = 2.63 + 0.24 + 0.24 = 3.11 kN/m per meter height
100 mm CHB = 2.5 + 0.24 + 0.24 = 2.98 kN/m per meter height

3. Floor Load

Materials Floor Load Roof Load


(kpa) (kpa)
100mm Slab 2.4
Floor Finish 1.10 -
Ceiling 0.348 0.348
MEP 0.10 0.10
Interior 1.00
Partition
Roof framing - 0.41
Corrugated - 0.10
roofing sheet
4. Live Load

Use or Uniform
Occupancy Load

Category Description kPa

Residentia Basic Floor Area 1.9


l
Restroom 1.9

DESIGN CRITERIA
Seismic Design Parameters

Seismic Zone Zone 4; Z=0.40


Seismic Source Type Type B
Importance Factor 1.0
Soil Type SD
Seismic Coefficient, Cv 0.64
Near-source factor, Nv 1.0
Seismic Coefficient, Ca 0.44
1.0
Near-source factor, Na
R Ω Cd
R.C Special Moment Resisting Frame 8.5 3.0 5.5

ALLOWABLE SOIL BEARING PRESSURE = 250 kPa (ASSUMED)

NOTE:
IN CASE SOIL BEARING PRESSURE IS DIFFERENT FROM THE ASSUMED VALUE,
FOUNDATION SHALL BE COMPUTED FOR THAT PARTICULAR VALUE

Wind Design Parameters


Basic Wind Speed, V 270 kph
Exposure Type Type B
Wind Directionality Factor, KD 0.85
Topographic Factor, KZT 1.0
Gust Effect Factor, G 0.64Nv
Enclosure Classification  Partially Enclosed
Internal Pressure Coefficient  ± 0.55

STAAD INPUT
STAAD OUTPUT
MANUAL COMPUTATION

You might also like