Scribd
Upload
69 views2 pages

NE40E - Logging in To A Device Through The Console Interface

Uploaded by

gabriel nava
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
69 views2 pages

NE40E - Logging in To A Device Through The Console Interface

Uploaded by

gabriel nava
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Logging in to a Device Through the Console Interface http://localhost:7890/pages/31183876/04/31183876/04/resources/dc_ne4...

Logging in to a Device Through the Console Interface


When setting up a local configuration environment through the console interface, you can log in to the NE80E/40E through
the HyperTerminal in Windows on the PC.

Prerequisite

Figure 1 Networking diagram of logging in to the NE80E/40E through the console interface

Before logging in to the NE80E/40E through the console interface, make sure that the NE80E/40E is properly powered on.

Procedure

1. Use a serial cable to connect the serial interface on the PC and the console interface on the NE80E/40E.
For details on the console interface, see HUAWEI NetEngine80E/40E Router - Hardware Description.
2. Start the HyperTerminal on the PC.
Choose Start > Programs > Accessories > Communications > HyperTerminal to start the HyperTerminal in
Windows.
3. Set up a connection.
As shown in Figure 2, enter the name of the new connection in the Name text box, and then select an icon. Click
OK.

Figure 2 Setting up a connection

4. Set a connection port.


In the Connect To dialog box as shown in Figure 3, select a port from the drop-down list box of Connect using
according to the port actually used on the PC or terminal. Then, click OK.

Figure 3 Setting a connection port

1 de 2 18/09/2013 12:33 a.m.


Logging in to a Device Through the Console Interface http://localhost:7890/pages/31183876/04/31183876/04/resources/dc_ne4...

5. Set communication parameters.


When the COM1 Properties dialog box is displayed as shown in Figure 4, set the COM1 properties according to
the description in Figure 4 or by clicking Restore Defaults.

Figure 4 Setting communication parameters

Operation Result

After the preceding configurations are complete, press Enter. If the prompt <HUAWEI> is displayed on the screen, it
indicates that logging in to the NE80E/40E through the console interface is successful. Then, you can run commands to
configure or manage the NE80E/40E.
If the login fails, click Disconnect and then Call. If the login still fails, repeat Step 1 to check whether the parameters or
physical connections are correct. If they are correct, log in to the device again.

Parent topic: Basic Commissioning

Huawei Proprietary and Confidential


Copyright © Huawei Technologies Co., Ltd.

2 de 2 18/09/2013 12:33 a.m.

You might also like