Lab Report 03 - Implement of 2D Drawing
Uploaded by
Joy PalLab Report 03 - Implement of 2D Drawing
Uploaded by
Joy PalGreen University of Bangladesh
Department of Computer Science and Engineering (CSE)
Faculty of Sciences and Engineering
Semester: Fall, Year: 2021, B.Sc. in CSE (Day)
LAB REPORT NO # 03
Course Title: Engineering Drawing
Course Code: CSE 208 Section: 203 DA
Lab Experiment Name: Implementation of 2D drawing.
Student Details
Name ID
1. Joy Pal 201002418
Submission Date : 15th December, 2021
Course Teacher’s Name : Mr. Montaser Abdul Quader
[For Teachers use only: Don’t Write Anything inside this box]
Lab Report Status
Marks: ………………………………… Signature:.....................
Comments:.............................................. Date:..............................
1. TITLE OF THE LAB EXPERIMENT
Implementation of 2D drawing.
2. OBJECTIVES
To learn the tools of AutoCAD 2022.
To learn the advance drawing technique of 2D drawing.
3. DESIGN and IMPLEMENTATION
Drawing – 1:
i. Specify the reference point and draw the line.
ii. Draw two circle with diameter 2.4 & 1.52.
iii. Again specify the other reference point and draw the line.
iv. Draw 3 circle with diagram 8.2, 4.8 & 3.6 and draw a circle
with radius 5.7 and trim the unnecessary lines.
v. Draw two circle with radius (tan, tan, radius) 1.6 and trim the
unnecessary lines.
4. OUTPUT
Drawing – 2:
i. Specify the reference point and draw the lines.
ii. Draw a circle with radius 56.
iii. Draw a circle with diameter 100.
iv. Draw 8 circle with radius 6.
v. Draw 8 circle with diameter 24.
vi. Trim the unnecessary lines.
vii. Draw 8 arc with radius 8.
OUTPUT
