Scribd
Upload
301 views1 page

Calculation To Provide Stirrups in Reinforcement of T10-200

The document discusses providing T10-200 stirrups instead of T8-150 stirrups as reinforcement in three locations - operational buildings in Allawa, staff quarters in WTP, and the Area Engineer's office in Polgahawela. T10-200 stirrups provide a shear resistant area of 393 mm2/m, which is greater than the 335 mm2/m provided by T8-150 stirrups, and are therefore sufficient to use instead.

Uploaded by

Sulakx Kuru
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
301 views1 page

Calculation To Provide Stirrups in Reinforcement of T10-200

The document discusses providing T10-200 stirrups instead of T8-150 stirrups as reinforcement in three locations - operational buildings in Allawa, staff quarters in WTP, and the Area Engineer's office in Polgahawela. T10-200 stirrups provide a shear resistant area of 393 mm2/m, which is greater than the 335 mm2/m provided by T8-150 stirrups, and are therefore sufficient to use instead.

Uploaded by

Sulakx Kuru
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

 Calculation to provide stirrups in reinforcement of T10-200

instead of T8-150
Locations
operational building –Allawa (Plinth beams, floor beam),
Staff quarters – WTP (Floor beams, Roof beams)
Area Engineer’s office – Polgahawela (Ground beams, Floor beams, Roof beams)

Provided reinforcement = T8-150


Provided shear resistant area in 1m per length = 335 mm 2/m.
T10-200 shear resistant area = 393 mm 2/m

So T10-200 is sufficient to provide instead of T8-150.

You might also like