Scribd
Upload
30 views1 page

EBBA Process Control - Assignment

The document provides instructions for a 60-mark executive bachelor assignment on process control. It outlines 3 questions to be answered regarding process flowcharts, process bottlenecks and continuous improvement, process lines, and statistical process control. The assignment requires drawing a process flowchart, identifying areas for revision, and explaining key terms with examples. Overall structure, formatting, and word count guidelines are also provided.

Uploaded by

Mohamad Syafiq
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
30 views1 page

EBBA Process Control - Assignment

The document provides instructions for a 60-mark executive bachelor assignment on process control. It outlines 3 questions to be answered regarding process flowcharts, process bottlenecks and continuous improvement, process lines, and statistical process control. The assignment requires drawing a process flowchart, identifying areas for revision, and explaining key terms with examples. Overall structure, formatting, and word count guidelines are also provided.

Uploaded by

Mohamad Syafiq
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Executive Bachelor – Assignment

60 Marks

Process Control (June 2020)


1. The ultimate goal of having students introduced with Process Control module is, to identify the existence of
processes around them and how they can initiate improvement in having the flow improved.
a) Students are required to draw a basic flowchart by using standard flowchart symbols available in the excel
spreadsheets. They may identify a process from their currently attached work. ( 10 marks)
b) Identify a minimum of 2 areas where the flowchart can be revised (can add or remove processes) and
explain why it was needed. ( 5 marks)
(You will need to review existing flow at your workplace and critically revise and suggest)

2. Give explanation with examples on the below mentioned terms:


a) Why do we need to identify process bottlenecks? How it can be eliminated? ( 5 marks)
b) What are the advantages and disadvantages of Assembly Line and Cell Line? ( 5 marks)
c) SPS or Statistical Process Control is an important tool used in manufacturing lines for process controls.
Discuss with relevant diagram and process that you understand. (5 marks)

3. Why continuous Process Improvement and Controls are very important to any organization regardless in
manufacturing or service line? Discuss critically. (10 marks)

Note:

1. Each points to be separated well with paragraphs


2. No bullet points allowed. Assignment must be in essay format.
3. Page Number, Table of contents, Citation, References or Bibliography are MUST.
4. Simple binding is encouraged – don’t waste $. Please print on both side of papers. Save trees.
5. Have a proper structure developed for each questions before attempt writing.
6. Keep simple wordings and total work should not exceed 3000 words and NOT less than 2500 words.

Good luck and Happy Learning!!

Prepared by : Saravanan Thailasam for WARISAN (June 2020)

You might also like