Scribd
Upload
250 views2 pages

Inspire 3

This document describes an automatic hand sanitizer dispenser that uses an infrared sensor to detect a hand below it and trigger a 9V pump to dispense sanitizer. When hands enter a 20cm detection range, the IR sensor activates an NPN transistor that controls the pump using a flyback diode for protection. A 9V battery powers the IR sensor, transistor, pump and optional buzzer. The goal is to automatically dispense the right amount of sanitizer when hands are in position to reduce contact with the dispenser.

Uploaded by

ZPHS. CHILUKUR
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
250 views2 pages

Inspire 3

This document describes an automatic hand sanitizer dispenser that uses an infrared sensor to detect a hand below it and trigger a 9V pump to dispense sanitizer. When hands enter a 20cm detection range, the IR sensor activates an NPN transistor that controls the pump using a flyback diode for protection. A 9V battery powers the IR sensor, transistor, pump and optional buzzer. The goal is to automatically dispense the right amount of sanitizer when hands are in position to reduce contact with the dispenser.

Uploaded by

ZPHS. CHILUKUR
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

Title-1 Automatic Hand-wash Sanitizer Dispenser

Working Principle:-

Internal Reflection in IR Sensor

Aim:- This device detects the presence of your hand and automatically release a specific amount of
Hand-wash / Sanitizer to your hand.

Experiment Description:-

Automatic hand wash dispenser which dispenses a specific a mount of handwashing liquid on to
your hands when placed under a distance measuring IR Sensor( Infrared Sensor).

Here the IR sensor is used to detect the presence of hand placed under the device ( 20 cm from the
sensor).

A 9V DC Pump is employed to eject the right amount of liquid at the right time. i.e. when the hands
are placed in the 20 cm range.

The DC Pump based on the distance obtained from the IR sensor.

The DC Pump is controlled via NPN Transistor (BC 547), a flyback diode (IN4007) is connected in
parallel with the motor. The diode protects the back produced by the pump.

An 9V Battery (9V 1 A DC Output) is used to power the 9V Pump.

Make sure the IR sensor is placed just above the outlet of the DC Pump so that it can detect the
hands kept under the outlet.

Use of Materials:-

1. 9V Battery
2. 9V Battery Snapper

3. DC Motor 9 Volt

4. IR Sensor Module

5. Transistors BC 547

6. Diodes IN 4007

7. Resistors

8. Connection Wires

9. ON/OFF Switch

10. Buzzer 9Volt

Conclusion:-

Automatic hand wash dispenser which dispenses a specific a mount of handwashing liquid on to
your hands when placed under a distance measuring IR Sensor( Infrared Sensor).

You might also like