plz find the answers and send it back to me tomaro with answers:

What is the wild card mask value for the network 192.168.30.64/27?
a) 0.0.0.31
b) 0.0.0.63
c) 0.0.0.7
d) 0.0.0.15

ans: A

Standard IP access lists are in the range?

a) 1-99
b) 100-199
c) 101-199
d) 401-500

Ans: A

What is the Well-known port number for EIGRP?

a) 642
b) 88
c) 510
d) 520

ans:88

To enable or disable terminal editing, your minimum privilege level needs to be?
a) global config mode
b) user exec
c) C)interface config mode
d) D)privilege

You have a Class C network, and you need eleven subnets. You wish to have as many
addresses available for hosts as possible. Which one of the following subnet masks
should you use?
a) 255.255.255.192
b) 255.255.255.224
c) C)255.255.255.240
d) D)255.255.255.248

ans: C

You have a Class C network, and you need ten subnets. You wish to have as many
addresses available for hosts as possible. Which one of the following subnet masks
should you use?
a) 255.255.255.192
b) 255.255.255.224
c) C) 255.255.255.240
d) D) 255.255.255.248

ans: C

You are troubleshooting a router that you believe it configured with an incorrect
IP address. You issue the show configuration command from privileged mode. Which
part of the output shows the specific configured IP addresses and subnet masks?
a) The IP host table.
 b) The interfaces output.
c) C) Each section of the output.
d) D) Each section of the output.
ans: B

Calculate the summary-address for the following subnets,10.0.192.0/22,

10.0.196.0/22, 10.0.200.0/22,10.0.204.0/22
a) 10.0.192.0/22
b) 10.0.192.0/21
c) C)10.0.192.0/20
d) D)10.0.192.0/16

1000% ans is C

Find out the Maximum subnets and valid hosts per subnet for the following IP
address 10.0.0.0/24
a) 65536 subnets, 254 valid hosts
b) 65536 subnets, 65534 valid hosts
c) C)256 subnets, 254 valid hosts
d) D)256 subnets, 65534 valid hosts

ans: A

Under the OSPF process of your router's configuration, you type in "redistribute
igrp 25 metric 35 subnets" in order to redistribute your OSPF and IGRP routing
information. What affect did the "subnets" keyword have in your configuration
change?
a) It resulted in OSPF recognizing non-classful networks.
b) It causes OSPF to accept networks with non-classful masks.
c) C)It had no effect since IGRP will summarize class boundaries by default.
d) D)It forced IGRP into supporting VLSM information.

sorry bhai...CCNA dubara padhni padegi saari...

Nyquist states
a) fs>=2fm
b) fs<fm
c) fs=fm
d) fs>2fm

ans : D

_______ is a procedure of converting an analog into a digital signal in which an

analog signal is sampled and then the difference between the actual sample value
and its predicted value (predicted value is based on previous sample or samples) is
quantized and then encoded forming a digital value.
a) Pulse code modulation (PCM)
b) Differential pulse code modulation (DPCM)
c) Time Division Multiplexing (TDM)
d) Synchronous Digital Hierarchy (SDH)

I think PCM

PCM-31 contains
a) FAS only
b) CAS
 c) CRC-4
d) All the above

The subscriber loop consists of two wires known as

a) Tip and Ring
b) Positive and Negative
c) Loop and Start
d) Ear and Mouth

Tip nd ring

CO stands for
a) Central Office
b) Carrier office
c) Calling Offset
d) None of the above

Ans'Centraol office

IEEE stands for

a) International union of Electrical and Electronics Engineers
b) Institute of Electrical and Electronics Engineers
c) International Institute of Electrical and Electronics Engineers
d) Indian Institute of Electrical and Electronics Engineers

Ans: B

What is the maximum cable length for 10BaseT topology?

a) 150 meters
b) 200 meters
c) 100 meters
d) 500 meters

ans 100 mts

Select which is not in this group

a) Phase-shift keying,
b) Frequency-shift keying
c) Amplitude-shift keying
d) TDM
ands: TDM

A______system provides for communication in both directions,but only one direction

at a time. a
) Full-duplex
b) Half-duplex
c) Simplex
d) None of the above

Ans: Hald Duplex

In communication the process of sending data one bit at one time,sequentially,over

a communication channel or computer bus is called
a) Asynchronous communication
 b) Synchronous communication
c) Parallel communication
d) Serial communication
ans: D

Point-to-Point protocol (PPP) is used as a WAN encapsulation between two routers.

Which one of the following is true regarding PPP?
a) PPP supports TCP/IP, but not Novell IPX.
b) PPP is being phased out of existence by the Serial Line Internet protocol.
c) PPP provides router-to-router and host-to-network connections over both
synchronous and asynchronous circuits.
d) PPP is an ITU-T and ANSI standard that defines the process for sending data
over a packet-switched data network.

C and D

Of the following choices below, only three could be used as WAN encapsulation
methods, as opposed to LAN encapsulation. Whic are they?
A) FDDI
B. HDLC
C. Frame Relay
D. PPP
E. Token Ring
F. Ethernet

a) A,B,C
b) B,C,D
c) C,D,E
d) D,E,F

ans : B

In a point to point connection between two offices, which PPP subprotocol

negotiates authentication options?
a) NCP
b) ISDN
c) SLIP
d) LCP

ans is D

What is the protocol number when TCP is connected with IP?

a)17
b) 6
c) 1
d) 512

ans : 6

What is the length of IPv4 address?

a) 32 bits
b) 128 bits
c) 64 bits
d) 8 bits

ans: 32
What is the range of private ip address?
a) 10.0.0.0/8, 172.16.0.0/16-172.31.0.0/16, 192.168.0.0/24-192.168.255.0/24
b) 10.0.0.0/24, 172.16.0.0/16-172.31.0.0/24, 192.168.0.0/24-192.168.255.0/26
c) 10.0.0.0/16, 172.16.0.0/16-172.31.0.0/18, 192.168.0.0/24-192.168.255.0/24
d) 10.0.0.0/24, 172.16.0.0/16-172.31.0.0/24, 192.168.0.0/24-192.168.255.0/24

What is the default TTL value which is used by router for all of its IP packets?
The current recommended default time to live (TTL) for the Internet Protocol (IP)
is 64
a) 32
b) 64
c) 128
d) 255

Which ISDN device converts the four-wire BRI signals from an S/T interface into the
two-wire signals of a U interface?
a) TE1
b) NT-2
c) C) TA
d) D) NT-1
NT1 hai ans....

Which two are facts about integrated services digital network (ISDN)?
a) ISDN provides only data only capability.
b) ISDN provides an integrated voice/data capability.
c) C)The ISDN standards define the hardware and call setup schemes for end-to-end
analog connectivity.
d) D)Users receive more bandwidth on WANs with a leased line of 56kbps than with
multiple b channels

ans: B ans D i think..B is for sure;...

What command providees the details on the Layer 2 transaction occurring between the
ISDN switch and the router?
a) debug dialer packet
b) debug isdn q931
c) C)debug ip packets
d) D)debug isdn q921

Which one of the layers of the seven layer OSI model uses positive acknowledgement
and retransmission to ensure reliable delivery?
a) Application
b) Presentation
c) C) Session
d) D) Transport

Ans : D

Which layer of the 7 layer OSI model does the ping command operate?
a) Session
b) Network
c) C) Transport
 d) D) Maintenance

ans : Network layer//

Which layer of the OSI model handles data translation, code formatting, and
encryption ?
a) Physical
b) Data link
c) C) Network
d) D) Presentation

Ans prsentatom/

Hubs are placed in which layer of OSI model?

a) physical layer
b) datalink layer
c) C) network layer
d) D) All 7 layers

hubs works: @ physical...

Which technology passes VLAN traffic across WAN links?

a) ISL
b) 802.1q
c) C)802.1q in q
d) D)MPLS

ans B

which priority value is selected automatically by PVST to run VLAN10?

a) 10
b) 32768
c) C)32778
d) D)65525
by defalut its B but if vlan 10 is aded then 10 will get added to B so answer is C

A new switch is installed into an existing LAN and a new VTP trunk is set up with
an existing switch. Which VLANs will be allowed on this new trunk?
a) All defined VLANs are allowed on the trunk by default.
b) Each VLAN, or VLAN range, that is specified with the switchport mode command.
c) C) Each VLAN, or VLAN range, that is specified with the vtp domain command.
d) D) Each VLAN, or VLAN range, that is specified with the vlan database command.
could be ans is B

Which International Telecommunication Union (ITU) G Series standard specifies a

voice stream operating at 8 Kbps?
a) G.711
b) G.726
c) G.728
d) G.729
ans D

Which result will occur if the Adaptive Differential Pulse Code Modulation(ADPCM)
is reduced from 32 Kbps to 16 Kbps?
a) Voice quality degrades as compression increases.
b) Voice quality improves as compression increases.
c) Voice quality degrades as compression decreases.
d) Voice quality is unaffected by compression rates.

ans A

Which International Telecommunication Union (ITU) G Series standard typically

provides the best voice quality?
a) G.711
b) G.723
c) G.726
d) G.729

ans : A

Which command enables inline power on port 3 of module 2 of a Cisco Catalyst 6000
Series switch that is running Cisco Catalyst software?
a) power inline in global configuration mode
b) power inline auto in interface configuration mode
c) set port inline power default
d) set port inline power 2/3 auto

You have configured SRST at a remote site on an MGCP gateway. During testing, you
find that IP phones are not registering with the SRST router when the IP WAN fails.
Which three potential problems need to be investigated? (Choose three)
A) The ccm-manager fallback-mgcp command is missing in the SRST router.
B) No dial peers have been added to the SRST router.
C) The max-dn command is missing in the SRST router.
D) The proper service command has not been added to the SRST router.
E) The max-ephones command is missing in the SRST router.
F) No SRST reference address is included in the device pool.
a) A,B,C
b) B,C,D
c) C,E,F
d) D,E,F

What is the most common E&M type used outside North America?

a) Type III
b) Type I
c) Type II
d) Type V
type V or 5 is th e correct answer

An Avaya customer with a large contact center is IP enabling their S87xx and will
allow 25 users to work from home via IP Agent in the Telecommuter mode. What is the
minimum hardware required in the S87xx to provide this application?
a) one CLAN board only
b) one Media Processor board only
c) one CLAN and one Media Processor board
d) D) no hardware is required, only software.
bhai dont expect answer from mw..

A customer wants to use an Avaya S87xx Media Server with Avaya G700 Gateways at
remote locations. Each G700 Gateway will include an S8300 Local Survivable
Processor and approximately 75 IP sets incorporating G.711. What Avaya feature
allows IP sets to register with the S8300 if connectivity to the S87xx is lost?
a) Local CLAN board
b) Alternate Gatekeeper
c) S8300 Auto-Registration
d) D) Gateway Alternate Redirection

bhai dont expect answer from mw..