Experiment No.:1 Preparation of Benzoic Acid From Toluene

Download as pdf or txt
Download as pdf or txt
You are on page 1of 5

EXPERIMENT NO.

:1

Preparation of benzoic acid from toluene

Reaction involved:

Chemicals required:
1. Toluene (5.1 g),
2. Potassium permanganate (17.5 g),
3. Potassium hydroxide (5mL 20% solution)),
4. Sulphuric acid (conc)
5. Sodium bisulphite

Procedure:

1. In a clean 250 mL three necked round bottom flask equipped with thermometer, water
condenser, magnetic stir bar and dropping funnel take 5 mL of 20% KOH solution,
45 mL of distilled water and 5.1 g of toluene.
2. Place the flask in an oil bath and heat up to 850C using temperature controlled hot
plate.
3. Toluene and water form azeotropic mixture which starts boiling at 85 0C.
4. Add KMnO4 solution (Made by dissolving 17.5 g of KMnO4 in 150 g of distilled
water at 700C) to the boiling solution of toluene and water dropwise for 15 minutes
using dropping funnel.
5. Allow the mixture to reflux for 1.5 hrs. If purple colour of KMnO 4 persists allow the
reflux for additional 15 minutes.
6. Add a few mL of ethanol to destroy excess KMnO 4 present.
7. Allow the solution to cool at room temperature and filter the solution under suction.
8. Take the filtrate in a 500 mL of beaker, add a pinch of sodium bisulphite and acidify
with dilute sulphuric acid.
9. White solid appeared in the beaker.
10. Filter the white solid.
11. Recrystallize the white solid from hot water (700C).
12. Record the yield and determine the melting point.
Oxidation mechanism by KMnO4
EXPERIMENT NO.:2

Separation of amino acids from their mixture by Paper Chromatographic


technique

Principle:

Paper chromatography wherein the substances are distributed or partitioned between liquid
phases. One phase is the stationary, which is held in the pores of the filter paper used and other
is the mobile phase which moves over the paper.

Capillary action: the movement of liquid within the spaces of a porous material due to the
forces of adhesion, cohesion, and surface tension. The liquid is able to move up the filter paper
because its attraction to itself is stronger than the force of gravity.

Solubility: the degree to which a material (solute) dissolves into a solvent. Solute dissolves into
solvents that have similar properties. This allows different solutes to be separated by different
combinations of solvents.

Separation of components depends on both their solubility in the mobile phase and their
differential affinity to the mobile phase and the stationary phase.

Chemical required:

1. Amino acids (L-Lysin, DL-Alanin, L-Leucine)

2. Acetic acid

3. 1-Butanol

4. Distilled water

5. Spraying reagent: Ninhydrin (0.3% solution in rectified spirit

Apparatus:

1. Measuring cylinder

2. Test tubes

3. Electric air oven


4. Solvent chamber (20 cm×4 cm)

5. Sprayer

6. Whatman No. 1 chromatographic paper (20 cm×4 cm)

Procedure:

1. Preparation of solutions (10-15 mg of each amino acid is mixed and dissolved in 1 ml distilled
water) and unknown amino acid in a separate test tube.

2. The chromatographic paper strip is taken and a base line is draw above 4 cm from the lower
end. Spots are given with the help of the capillary tubes.

3. Developing solvent- Butanol: AcOH : H2O =12:3:5 and poured into the jar before 1 hr. of
developing and lid is placed properly.

4. Development of the chromatogram.

5. Drying in oven.

6. Spraying.

7. Location of the spots with pencil.

Calculation:

The movement of any substance relative to the solvent front in a chromatographic system is
Constance. In paper chromatography it is defined as,

RF value- Distance moved by the substance/distance moved by the solvent front.


Ninhydrin Purple colour

You might also like